Bedienungsanleitung Fein DUSTEX 35L (Seite 28 von 272) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

577144

Zoom out

Zoom in

Vorherige Seite

1/272

Nächste Seite

The connected load of the power tool

may not exceed the maximum con-

nected load P

of the vacuum

cleaner’s socket outlet.

Please also observe the operating

instructions and safety warnings of

the power tool being connected to the

socket outlet of the vacuum cleaner.

Recommendation: Always operate the

vacuum cleaner via a residual current

device (RCD) with a rated residual

current of 30 mA or less.

The vacuum cleaner may only be

stored indoors.

Operating Instructions.

Operation, see page 10.

Filter replacement and filter cleaning,

see page 11–13/ 30 section “Fault

Finding.”

Never vacuum with-

out the flat-fold filter,

as otherwise the motor will be dam-

aged and a health hazard will occur

through increased exposure of fine

dust. When vacuuming fine dust, a

fleece filter bag must be used addi-

tionally.

An adequate ventilation rate L must

be provided for when the outgoing air

is circulated. The circulated airflow

must not exceed 50 % (max.) of the

fresh air volume (room volume x ven-

tilation rate L

). The following applies

without special ventilation measures:

=1h

-1

When inserting the fleece filter bag,

pay attention that the closing cover

and the fleece bag face completely

against the interior side of the con-

tainer.

After removing the fleece filter bag,

seal it with the closing cover in order

to avoid debris.

For vacuuming dusts of dust cate-

gory L, only dry flat-fold filters,

which have not been moist or wet,

are permitted to be used.

Before switching from wet to dry

vacuuming, allow the flat-fold fil-

ter to dry or replace through a dry

one. Otherwise, the flat-fold filter will

become unusable.

Keep the flat-fold filter dry and clean

it regularly.

Mount accessories applying only slight

pressure. For disassembling, turn the

parts somewhat against each other

and pull apart.

Switch the vacuum cleaner off before

connecting a power tool to the vac-

uum cleaner’s socket outlet. Make

sure that the power tool is switched

off when inserting its plug into the

vacuum cleaner’s socket outlet.

After switching off a power tool con-

nected to the vacuum cleaner’s socket

outlet, the vacuum cleaner will run on

for approx. 15 seconds and then

automatically switch off.

When wet vacuuming electrically con-

ductive liquids, the vacuum cleaner is

automatically switched off (automatic

shut-off) when reaching the maximum

filling height of the container. Pull the

mains plug from the socket outlet and

empty the container.

When wet vacuuming electrically

non-conductive liquids (e. g., oils,

drilling emulsions), the vacuum

cleaner is not automatically switched

off when reaching the maximum filling

height of the container. Empty the

container in time.

CAUTION

OBJ_BUCH-0000000148-001.book Page 28 Tuesday, February 25, 2014 12:35 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fein DUSTEX 35L Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info