502067
18
Zoom out
Zoom in
Vorherige Seite
1/85
Nächste Seite
18
en
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
First check that the mains sup-
ply lead and mains plug are
not damaged.
Always hold the power tool
firmly. Otherwise, you could
lose control over the power tool.
WSG10T/WSG14T: Press the locking but-
ton only when the motor is stopped.
Starting (Figure 9).
After inserting the mains plug, the angle grin-
der can be started in any working position by
pressing the pressing surfaces twice in succes-
sion.
Hold the angle grinder in the required
working position, either at the
back (START A) or front (START B); lightly
press at least one of the 4 pressing surfaces,
and keep it/them pressed.
Please note: The accessory begins to move
with short, low-power impulses. The angle
grinder thereby indicates that the first pres-
sing surface has been activated.
For the working position holding the power
tool at the back (START A):
Briefly press one of the front switch-
pads (close to the auxiliary handle) with
your thumb.
For the working position holding the power
tool at the front (START B):
Briefly press one of the rear switch-
pads.
The angle grinder starts gently and rea-
ches its working speed after a short time.
Please note: The angle grinder does not start
up:
when the switchpads at the front and rear
are pressed at the same time
when the rapid-clamping lever is not tilted
back and engaged
if one or more of the pressing surfaces is/
are pressed while the mains plug is inserted
WARNING
WARNING
CAUTION
Fig. 9
3 41 01 121 21 0.book Seite 18 Mittwoch, 20. Mai 2009 2:23 14
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fein WSG14 150T wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info