Bedienungsanleitung Felisatti RGF150 (Seite 5 von 26) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

502503

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

The flexible hoses of conventional vacuum cleaners fit

directly onto the dust extraction nozzle.

The aspirator should be suitable for the material being

worked.

A special aspirator must be employed in those cases

where dry harmful or carcinogenic dust is produced.

ACCESSORIES

Accessories and their corresponding order number can

be found in our catalogues.

MAINTENANCE AND CARE

WARNING! Always unplug the machine before carrying

out work on it.

- Inspect the tool: Using a worn out polishing or polish-

ing tool will reduce working efficiency.

- Inspect the mounting screws: Regularly inspect all

the mounting screws and ensure they are firmly tight-

ened. Should any screw be loose, tighten it immedi-

ately. Failure to do so could put you at serious risk.

- Motor maintenance: Always take the greatest care

over this and make sure that the motor winding is not

damaged and does not become wet with oil or water.

- The vents should always be kept clean and free of

obstacles.

- Clean the machine thoroughly after each use. Blast the

motor regularly with compressed air.

- Check that the mains lead is in good condition. If

it is not, take it to an Official Service Centre to

have it replaced.

- Brush replacement: The brushes should be replaced

after 150 - 200 hours use or when they are less than

10 mm long. Have this done by an Official Service

Centre. We recommend that at every second change

of brushes, you take the machine to one of our Official

Service Centres for general cleaning and oiling.

- Use only Felisatti accessories and spares. Parts the

changing of which is not covered in this instruction

manual, should be replaced in a Felisatti Official

Service Centre (See Warranty/Official Service Centre

address leaflet).

Do not dispose of electric tools in

the household waste!

In accordance with European Directive 2002/96/EC

relating to old electrical and electronic appliances and

its translation into national law, used electric tools must

be collected separately and recycled in an ecologically

desirable way.

WARRANTY

See general warranty conditions printed on the attached

sheet.

NOISE AND VIBRATION

This tool has been designed and made to reduce noise

to a minimum. However, in spite of this, in certain

circumstances the maximum noise level in the place

of work could exceed 85 dBA. In this case, the op-

erator should wear ear protection.

The machine's noise and vibration levels, measured in

compliance with EN60745-1, usually reach:

Acoustic pressure = 82 dB(A)

Sound-power level = 92 dB(A)

Use ear protection!

Vibration acceleration = 7.5 m/s

DECLARATION OF CONFORMITY

We hereby declare, under our sole responsibility,

that the FELISATTI brand products described in

this manual RGF150/600E comply with the

following standards or standard documents:

EN60745-1:2008, EN55014-1:2006+A1,

EN55014-2:1997+A1+A2, EN61000-3-

2:2006+A1+A2 and EN61000-3-3:2008 in accor-

dance with EU Directives 2006/42/EC,

2006/95/EC, 2004/108/EC and 2002/95/EC.

Francisco Ruiz

Plant Mgr.

We reserve the right to make technical changes 09/2001

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Felisatti RGF150 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info