T echnical Specificationen:
• Bluetooth-V ersion: V5.0
• Profile: HSP /HFP/ A2DP/ A VRCP
• Battery capacity earbuds 40mAh / pcs, 40mAh x 2,
Li-Polimer battery
• Battery capacity charging-box 250mAh, Li-Polimer battery
• Charging time: approx. 50min. for earbuds,
1-2 h for the charging-bo x
• Connector/V oltage: micro USB / 5V DC
• T alking time: up to 9 hours (incl. Charging-Box)
• Playing time: up to 3 hours / max. 9 hours (incl. Charging-Box)
• Loudspeaker: Ø13 mm, 3 mW, 32 Ohm
• SNR: 112 dB ± 3dB
• Frequency response: 20Hz -20KHz
• Auto Power On / O: automatically ON/ OFF
• Auto Pairing: autom. re-pairing (when talking out of the
charging-box)
1) ON/OFF and P AIRING (with a Bluetooth device):
a. T ake out the earbuds from the pack aging und put into the
charging-box (mak e sure it is loaded).
b. Tak e them out again of the charging-box. The earbuds now are
ON automatically and in pairing-Mode.
c. The „red/blue“ LED on both earbuds start to flash.
d. After a few seconds only the „ red/blue “ LED on left earbud
flashes (Master). This means, that both earbuds are connected
to each other now and ready to pair with Bluetooth device
(e.g. Smartphone , tablet,…).
e. Now, look f or „AERO light“ in the Bluetooth-List of your Bluetooth
device (check manual of your device) and click it to connect
automatically (without need of a PIN-Code).
f. After pairing is successful, the „red“ LED turns into “blue” and
flashing once every 5 seconds.
g. R emark: After first time connection, in future, the earbud will be
connected with your mobile automatically as long as you power
on the earbud and your mobile´s Bluetooth is on and you didn ’t
delete “ AERO light” on your BT list from y our device.
2) Power OFF:
Press the control-button on both earbuds mor e than 3 seconds,
or put them into the charging-box. If you pow er o only one of the
earbuds, the other one will power o too.
4) Functions (Music / Calls):
a . Play/Pause: When playing music, short pr ess any earbud‘s
control button to Stop/Playing music .
b. Next song: When playing music, press and hold 1.5seconds
of any earbud‘ control button to switch into next song (pay
attention: long press 3 seconds will power o).
c. Hang on (talk a call): When calling comes, short press any
earbud‘s control button.
d. Decline a call: Press and hold an y of the earbud‘s control button
for 1.5 seconds to decline the calling (pay attention: long press
3 seconds will power o ).
e. Hang o (end call): When under calling, short press any earbud‘s
control button to end the phone call.
f. Recall: Quick double press any of the earbud‘ s control button
to recall the last No. on y our calling list of mobile.
g. Pow er o: Press and hold the earbud’s control button for
3 seconds.
5) F AQ / Question
a. AERO light cannot be found in BT list of y our Bluetooth device.
i. Check, if AERO light is ON.
ii. Check if AERO light is in “Pairing-Mode” . If not, put both
earbuds into charging-box. Then took them out again, wait
some seconds to get the earbuds connected each other ,
then start pairing with y our Bluetooth device again.
iii. AERO light already is connected to another device (pls check).
3) Charging:
a. When fully loaded the working-time is about 2 -3 hours.
Using the fully loaded charging-box (with integrated battery)
AERO light can be loaded up to 3 times. So, the complete
working- time can be extended up to 9 hours without having
connection to power plug.
b. Indicator battery of charging-box is weak:
i. The „red“ LED starts flashing every 5 seconds and y ou hear
a w arning tone in the earbud (during using).
c. Anzeige Akku der Ladebox ist schwach:
i. Only one „blue“ LED on the charging-box is on and it
starts flashing.
d. Charging the char ging-box:
connect it with the included micro USB-cable and a
compatible charging device (5V DC , 1A; not included), e.g.
the one of your smartphone or similar .
i The two „red“ LED flashing slowly during char ging.
ii. The charging-time is about 1-2 hours.
iii. When fully loaded, the two „red“ LED´s stop flashing.
e. Charging the Earbuds: put both earbuds into the charging-
box – charging starts automatically .
i. During charging, the „red“ LED on earbuds ar e lighting.
Same time the LED on charging-box lighting „blue“ . If box is
fully loaded, tw o „blue“ LED are on, if box is not fully loaded
only one “blue” LED is on.
ii. „Blue“ LED gets o , when the earbuds are fully loaded.
iii. This needs up to about 50 minutes
(if earbuds ar e completely empty).
f. Indicator battery weak during using (music or call):
i. If battery of earbud is quite empty (voltage below 3 .2V), the
„r ed“ LED starts flashing once every 5 seconds. When it
flashed 3 times quickly and y ou hear a sound warning tone,
it will go Power O .
ii. Please charge them immediately .
Thanks a lot, that you choosed our AERO light.
Please read this manual car efully before first using.
Bluetooth is a trademark owned by the Bluetooth SIG , Inc. iv . Other possibilities:
1. Switch OFF the Bluetooth function on your Smartphone
and switch it ON again. Then r e-start pairing.
2. Delete some Bluetooth connected items on your Smartphone
to have again space for new ones. Then again re-start pairing.
b. Connection of the earbuds to the smartphone gets interrupted
during using, or you cannot hear any sound ev en existing
connection (and loudspeaker -level is not o ):
i. Maybe batteries of earbuds are quite empty . Put them into
the charging-box for loading. After loaded, start again.
ii. The distance between earbuds and smartphone is too high.
Pls low er the distance (max. distance is about 10m, best is
below 2m; f or pairing best below 0.5m).
iii. Pairing was not completed successfully . Switch ON/OFF .
earbuds and start pairing / connection once more .
6) Warr anty (6 months warranty)
a. This includes no mechanical defects, no w ater defaults caused
by customer .
b. In case of defects please contact your dealer (provide y our
bill – so take car e of it).
7) Cleaning & Security
a. Keep aw ay from children.
b. As the item is not waterproof ed, always keep it dry (no rain,
water or other liquor).
c. If getting wet, let it first dry completely .
d. Always k eep it clean – dust and mud can destroy the electronical
parts.
e. Beware it from heat and cold. Both can damage or r educe life on
the in-built battery .
f. Don´t try to open the item – warranty will be lost.
g. Don´t use heavy cleaning utensils or chemical cleaning supplies.
Only use a soft cloth.
Manual
True Wireless Stereo Earbuds
AE RO ligh t
Control-button
Earbuds (2x)
T op of charging-box with
magnetic closure
LED
Charging-Box
Micro USB charging connector
on backside
LED charge-control/ capacity:
1 LED 50%/2 LED 100% charged
Declaration of Conformity (DOC)
Manufacturer: Bea-fon Mobile GmbH
Enzing 4, 4722 Peuerbach, Austria
Importer: Bea-fon Mobile GmbH
Website: www .beafon.com, www. felixx.com
Model: BH-AERO-2 / HP-040
Description: Bluetooth Headset
Shenzhen Anbotek Compliance Laboratory Ltd, 1/F , Building D,
Sogood Science and T echnology Park, Sanwei community, Hang-
cheng Street, Bao´an District, Shenzhen, Guangdong, China, 518102
did following CE Certificate (Certificate Nr .: A TSZAWW191120002):
This model fulfills the essential requirements of following EU Dir ective:
Radio Equipment Directiv e (RED) 2014/53/EU
This declaration of conformity is under the sole r esponsibility of the
importer , Bea-fon Mobile GmbH:
T est Standards: EN 62368- 1:2014+A11:2017
ETSI EN 301489- 1 V2.1. 1 (2017-02)
EN 55032: 2015 / EN 55035: 2017
ETSI EN 301489- 17 V3.1. 1 (2017-02)
ETSI EN 300328 V2.2.2 (2019-07)
EN 62479:2010
T est Report Nr .: SZAWW191120002-02S, SZAWW19112002 -03H,
SZAWW191120002-04W, SZAWW191120002 -01E
Description of accessories:
- USB cable
- Batterie (charging-box): 3 ,7V 250mAh Li-Ion (in-built)
- Batterie (earbuds 2x): 5V 40mAh Li-Ion (in-built)
Signed:
Reinhard Handlgruber , CCO
Peuerbach, 18. 12.2019 Bea-fon Mobile GmbH
Enzing 4, 4722 Peuerbach, Austria
BH-AERO-2_Manual_DE_EN.indd 7-12
BH-AERO-2_Manual_DE_EN.indd 7-12
06.03.20 16:17