Setup device via brand name code
1. Switch on the device that you like to control.
2. Find the code number of your device brand in the code list (e.g. Ferguson 1244) from the
relevant device group (e.g. DVB-T).
3. Press and hold the device button (e.g. AUX) for three seconds. Release the device button as
soon as LED lights up, now it is in set up mode.
4. Enter the 4-digit device code (e.g. 1244 for Ferguson DVB-T) within 10 seconds. If an entry
is not made within 10 seconds, the set- up mode is automatically terminated.
5. The LED turns off if the remote accepts the code. If the LED flashes three times, that means
the code may be wrong, and the remote control remains in set-up mode, enter the correct
code from the list again in good time.
6. Check the function of the buttons on remote control. If it does not function correctly, try
another 4-digit device code from the list under the same brand. Repeat steps 3 to 6 until all
the basic functions operate correctly.
7. Exit the set-up mode by pressing the device button.
Note:
• If you are not satisfied with certain buttons assignments, or some functions are missing,
then you can use additionaly learning function.
• mode is automatically terminated if no button is pressed for 10 seconds.
Setup device via manual search
1. Switch on the device that you like to control.
2. Point the remote control at the device. Press and hold down the device button (e.g. TV) for
3 seconds. The LED lights up and the remote is in manual set-up mode, release the device
button now.
3. Press the Vol+ button approx. every 1.5 seconds.
4. As soon as the volume of the device (e.g. TV) changes or the device turns off, check
whether the other buttons on the remote control function correctly. If the majority of the
buttons does not function correctly, press the Vol+ approx. every 1.5 seconds to initiate the
reactive code (manual search is continued, see steps 3 to 4).
5. If the majority of the buttons on the remote control functions correctly, save the code by
pressing the device button (e.g. TV) to terminate the manual search.
Note:
• If you are not satisfied with certain buttons assignments, or some functions are missing,
then you can use additionaly learning function.
• Sometimes, remote control does not work properly just because manual search was not
stopped in time. In this case, just enter into manual search again, and press Vol– button
approx. every 1.5 seconds to search backward the code database.
•
The Manual Search is automatically terminated if no entry occurs during 30 seconds period.
•
Manual search mode, search forward from the current code.
Learning Function
The learning function is used to extend the pre-programmed codes. The standard code list
already provides you with the most important functions, but it is possible to add a few
additional functions. A fully functional original remote control is required for learning
programming.
Please use fresh batteries for both the Learning Remote Control and the Original Remote
Control.
8
