Bedienungsanleitung Ferm CRM1028 FCO-1006 (Seite 7 von 48) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

538648

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Ferm 07

Extension cables

Only use an extension cable with a plug and earth, so never use damaged or flattened

extension cables. Check whether the extension cable is in a good condition. For this device

the extension cable should have a diameter of at least 2.5 mm

(this applies to a maximum

length of 20 metres). Always unroll extension cables fully before using them.

Electrical connection

Always check whether the input voltage of the motor corresponds to the mains voltage

indicated on the specification plate. The compressors are supplied with an electrical cable

and a two-pole plug + earth. It is important to connect the compressor with an earthed plug

socket. (fig. 9)

Never use the earth-wire instead of the neutral (0-wire). The earthing should take

place in accordance with accident prevention regulations (EN 60204).

3. USE

For homehold use only

NB: The information you will find in this manual has been written to assist the operator in the

use and maintenance of the compressor.Some illustrations in this manual show details which

may differ from those of your compressor.

Installation

After having taken the compressor out of its packaging (fig. 1) and having checked that it is in

perfect condition, and having noted that no damage occurred during transport, the following

acts should be performed. If not yet fitted, fit the rubber feet on the tank according to the

instructions represented in fig. 2. Place the compressor on a flat surface or at a maximum

slope of 10° (fig.3), in a well ventilated area, protected against atmospheric factors and not in

explosive surroundings. If the surface area is sloping and smooth, make sure that the

compressor will not move when in operation. If the surface area is a board or a shelf of a

bookcase, just make sure that they cannot fall down by securing them properly. For proper

ventilation and effective cooling, it is important that the compressor is positioned at least 100

cm from the wall (fig. 4).

Make sure that the compressor is transported in the right way, do not turn it upside

down and don't lift it with hooks or ropes (fig. 5-6).

Important! Before commissioning

Remove the plastic cap from the sump lid. Fill the sump with the oil supplied. The gauge at the

bottom of the sump indicates the oil level: this should now be level with the red dot (fig. 7 and

8).

FIN

Ferm

• Fyld olie på via det øverste hul på beholderlåget (fig.18) indtil måleinstrumentets

indikation på pakningen (fig. 8) er nået. Check pumpensystemets olieniveauet hver uge,

og fyld om nødvendigt.

For drift under omgivende temperature på of -5°C til + 35°C anvend syntetisk olie “SAE

10W30”. Den syntetiske olie har den fordel at den ikke mister dens karakteristisk, hverken om

sommeren eller om vinteren.

Du bør ikke hælde brugt olie ud i afløbet eller naturen.

Overhold venligst nedenstående tabel, ved udskiftning af olie.

Olietype Driftstimer

Kvalitetsolie SAE 10W30 100 eller 6 måneder

Fejl

Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på

garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan

bestilles.

Miljø

Foratundgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så

vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.

Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på

en genbrugsplads.

Garanti

Garantibetingelser er beskrevet på det separat vedlagte garantibevis.

FIN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm CRM1028 FCO-1006 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info