Montage og indstilling af parallellederen
Fig. C.
Parallellederen er egnet som hjœl pemiddel ved frœsning
af et smalt arbejdsstykke.
• Parallellederen er egnet som hjœl pemiddel ved frœs-
ning af et smalt arbejdsstykke.
• Saml parallellederen. Fastgør lederstœngerne (18)
på rammen (14) ved hjœlp af boltene (19).
• Drej klemskruerne (4) løs og skub lederstœngerne i
optagelserne (5).
• Indstil parallellederen på den ønskede ledningsaf-
stand.
• Skru klemskruerne fast igen.
Montage af skabelonlederen.
Fig. D.
Skabelonlederen er egnet som hjœlpemiddel ved frœs-
ning ifølge et mønster.
• Montér skabelonlederen (15) ved hjœlp af skruerne
(17) og møtrikkerne (20) på frœsesålen (3).
Ferm 39
Switching on and off (Fig. A).
• To switch the machine on, you press the on/off switch
(1). You can adjust the cutting speed by turning the ad-
justing wheel (13).
• To switch the machine off, you release the on/off
switch.
Always select a low speed for cutting plastic
workpieces.
Do not put the machine down when the motor is still run-
ning. Do not place the machine on a dusty surface. Dust
particles may enter the mechanism.
MAINTENANCE
Make sure that the machine is not live when car-
rying out maintenance work on the motor.
The Ferm machines have been designed to operate over
a long period of time with a minimum of maintenance. Con-
tinuous satisfactory operation depends upon proper ma-
chine care and regular cleaning.
Cleaning
Regularly clean the machine housing with a soft cloth, pre-
ferably after each use. Keep the ventilation slots free from
dust and dirt.
If the dirt does not come off use a soft cloth moistened with
soapy water. Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may damage the
plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please con-
tact your local Ferm dealer.
In the back of this manual you find an exploded view
showing the parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage during trans-
port, it is delivered in a sturdy packaging. Most of the pack-
aging materials can be recycled. Take these materials to
the appropriate recycling locations.
Take your unwanted machines to your local Ferm-dealer.
Here they will be disposed of in an environmentally safe
way.
GUARANTEE
The guarantee conditions can be found on the separately
enclosed guarantee card.
ClEl
■
DECLARATION OF CONFORMITY
(
GB
)
We declare under our sole responsability that this
product is in conformity with the following
standards or standardized documents
EN50144-1, EN50144-2-17,
EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-3
in accordance with the regulations.
98/37EEC
73/23EEC
89/336/EEC
from 26-05-1998
GENEMUIDEN NL
G.M. Ensing
Quality department
6 Ferm
