54 Ferm
CORDLESS SCREWDRIVER
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
INTRODUCTION
This screwdriver is intended for tightening and
loosening screws and nuts. It has a device for setting the
torque and switching off the rotation.
TECHNICAL SPECIFICATIONS
FEATURES
Fig. A & C
1. Hexagonal drive shaft
2. Torque setting ring
3. Direction switch
4. Keyless chuck
5. Battery release button
6. Battery with red charging LED
7. Ring
8. Accessories
PACKAGE CONTENTS
1 Cordless screwdriver
1 Charger
2 Batteries
1 Keyless chuck (max. 6 mm)
1 Magnetic bit holder
1 Adapter bit for socket
44 Accessories
1 Instruction manual
1 Safety instructions
1 Warranty card
Check the machine, loose parts and accessories for
transport damage.
SAFETY INSTRUCTIONS
The following symbols are used in these instructions for
use:
In accordance with essential applicable safety
standards of European directives
Class II machine – Double insulation – You don’t
need any earthed plug.
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
Indicates electrical shock hazard.
Read instructions carefully
Indoor use only
Always recycle batteries
Never throw batteries into open fire
In case of failure, the transformer is not dangerous
Thermic protector
Faulty and/or discarded electrical or electronic
apparatus have to be collected at the appropriate
recycling locations.
Carefully read this manual before using the machine.
Make sure that you know how the machine functions and
how to operate it. Maintain the machine in accordance
with the instructions to make sure it functions properly.
Keep this manual and the enclosed documentation with
the machine.
ELECTRICAL SAFETY
Check that your mains voltage corresponds to the
input voltage of the charging adapter.
The charging adapter is double insulated in
accordance with EN-60335; therefore no earth
wire is required.
ADDITIONAL SAFETY INSTRUCTIONS.
If you should come into contact with any acid
from the accumulator block, wash the affected
parts with water immediately. If acid should
come into contact with the eyes, rinse them
immediately with water and seek medical advice as
soon as possible.
1. Before using both the accumulator block and the
battery charger, make sure you have read and
understood the operating instructions and safety
information.
2. Only use the accumulator block with the battery
charger provided – using other chargers could be
dangerous.
3. Keep the accumulator block, tool and battery
charger away from damp and wet conditions.
4. Before using the battery charger, check all wires are
properly connected.
Voltage | 4.8 V
—
---
Voltage charging adaptor | 230 V
Frequency | 50 Hz
Capacity battery | 1.3Ah
Charging time | 3-5 hours
Number of torque | 5
Speed. No load | 190/min
Weight (incl. battery) | 0.67 kg
Vibration | 0.48 m/s
2
Ferm 3
