Ferm 79
Rengøring
Rengør regelmæssigt maskinhusene med en blød klud, helst efter hver brug. Sørg for, at
ventilationsåbningerne er fri for støv og snavs. Fjern vedholdende snavs ved hjælp af en klud,
der er fugtet med sæbelud. Brug aldrig opløsningsmidler, som f.eks. benzin, sprit, salmiak osv.,
da sådanne kemikalier beskadiger de syntetiske dele.
Smøring
Smør regelmæssigt borehammerens aksel.
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så
vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
en genbrugsplads.
Garanti
Se venligst garantibetingelserne på garantikortet, som er vedlagt separat.
DK
06 Ferm
• Whenever any of the problems mentioned above appear, immediately cease using
the machine and have it repaired by an expert.
Electrical safety
Always check that the mains voltage is the same as on the type plate of the
machine.
The machine is double insulated compliant with EN50144; therefore, no earth
connection is required.
Replacement of power cords or plugs
Immediately dispose of old cords and plugs once they have been replaced. It is dangerous to
plug a loose power cord into a mains power socket.
Use of extension leads
Only ever use approved extension leads that are suitable for the power rating of the machine.
The minimum core thickness is 1.5 mm2. Whenever using a reel extension lead, always fully
unroll the lead.
3. OPERATING
Hammer drills require very little operator pressure. Excessive pressure on the tool
can lead to unnecessary overheating of the motor, and burning of the driven tool.
Auxiliary handgrip
The auxiliary handgrip can be rotated 360º around the drill head, enabling safe and comfortable
operation, for both left and right-handed users.
• Loosen the handgrip by turning it anticlockwise.
• Rotate the handgrip to the desire position.
• Retighten the handgrip in the new position.
Exchanging and removing drill bits
Fig. A + B
Before exchanging bits, first remove the power plug from the wall socket.
Inspect bits regularly during use. Blunt bits should be re-sharpened or replaced.
• Lightly oil the bit shaft before inserting it into the chuck.
GB
