Ferm 05
1 Depth gauge
1 Drill chuck with chuck key
1 Can of lubricating grease
1 Dust catcher
3 Hammer drill bits
2 Chisels
1 Pair of carbon brushes
1 Set of operating instructions
1 Guarantee card
Details
Fig. A + D
1. ON/OFF switch
2. Handle selection switch drilling - hammering
3. Front selection switch demolition - hammer drilling
4. Bumper
5. Carbon brush cap
6. Grease cap
7. Auxiliary handgrip
8. Depth gauge
9. SDS 10 chuck
10. Dust catcher
2. SAFETY REGULATIONS
Explanation of the symbols
The following symbols are used in these instructions and on the device:
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
Indicates electrical shock hazard.
Wear ear and eye protection
Device Class II – double insulation – No grounded connector plug is required.
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
Special safety instructions for hammer drills
a. Attention! The use of accessories or additional devices other than those recommended in the
operating instructions, or those included in the scope of delivery, can pose an injury hazard.
GB
D
NL
F
E
P
I
S
FIN
N
DK
92 Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
