Bedienungsanleitung Ferm HDM1027S (Seite 6 von 116) (Alle Sprachen)

762287

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

Description

The numbers in the text refer to the diagrams on

pages 2-3

Fig. A





3. Speed adjustment wheel

4. Lock-on button

5. Function selection switch

6. Side handle

7. Locking sleeve

8. Depth stop ruler

3. OPERATING

Hammer drills require very little operator

pressure. Excessive pressure on the tool

can lead to unnecessary overheating of

the motor, and burning of the driven tool.

It also may happen the drill bit deforms

and cannot be removed from the

machine again.

Side handle

Fig. A

The side handle (6) can be rotated 360° around

the drill head, enabling safe and comfortable

operation for both left and right-handed users.

• Loosen the handgrip by turning it

anticlockwise.

• Rotate the handgrip to the desired position.

• Retighten the handgrip in the new position by

turning it clockwise.

Exchanging and removing drill bits

Fig. A - B

Before exchanging bits, first remove the

power plug from the wall socket.

Inspect bits regularly during use. Blunt

bits should be re-sharpened or replaced.

• Lightly oil the bit shaft before inserting it into

the chuck.

• Slide the locking sleeve (7) to the rear and

insert the bit into the chuck opening. Ensure

that the keyway in the bit is seated properly

in the chuck by carefully turning the bit until it

clicks into place. After that release the locking

sleeve.

• To remove the bit, slide and hold the locking

sleeve to the rear.

Setting depth stop

Fig. A

• Loosen the handgrip by turning it

anticlockwise.

• Insert the depth stop ruler (8) through the hole

in the side handle ring.

• Slide the ruler to the desired depth.

• Retighten the hand grip firmly by turning it

clockwise

The On/Off switch

Fig. A

 



(2) the machine will turn off.

• The rotation-speed can be continuously



deeper or less deep.

Lock-on button

Fig. A

 

Off switch (2) and then pressing the lock-on

button (4).

• Release the switch-lock by shortly pressing



Adjusting of the maximum rotation speed

Fig. A

 

switch (2).

 

lock-on button (4).

• Adjust the speed by turning the speed

adjustment wheel (3) to the desired maximum

rotation speed.

Switching the direction of rotation

Fig. A.

• Direction of rotation counter-clockwise: shift

 ”.

 

 ”.

This function is only available when the machine



Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm HDM1027S Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info