5.
•
•
,
.
:
EN 50144-1, EN 50144-2-15, EN 55014-1
EN 55014-2, EN 61000-3-2, EN 61000-3-3
:
98/37/, 73/23/, 89/336/,
01-01-2004
ZWOLLE-NL
W. Kamphof
,
.
Ferm BV, Zwolle,
CE
ı
(
GR
)
52 Ferm
TRIMMING A HEDGE - BEST METHOD
Ideally a hedge should be wider at the bottom than the
top. This will improve light penetration, keeping the
hedge healthy. If possible, trim both sides of the hedge.
When trimming the sides of the hedge, trim from the
bottom upwards. This will ensure there are no hedge
trimmings obscuring or interfering with your cut
strokes.
The blade should not be forced to cut too deep. Cut
lightly through the surface of the hedge.
When trimming the top of the hedge, trim away from
you but do not over-reach. It is much wiser and safer to
move along and cut within your reach remaining on two
feet at all times.
Warning! Do not let the blade come into contact
with wire meshing or fencing material. It could
damage the material and your trimmer.
TROUBLE SHOOTING
The following table gives checks and actions that you can
perform if your machine does not operate correctly. If
this don’t identify/remedy the problem, contact your
service centre.
Warning ! Switch off and remove the plug from
the mains before investigating a fault.
1. Machine fails to operate
• Power turned off
Turn power on
• Mains socket faulty
Use another socket
• Extension cable damaged
Inspect cable, replace if damaged
• Fuse faulty/blown
Replace fuse
2. Machine overheats
• Air vents blocked
Unblock air vents
3. Machine functions intermittently
• Extension cable damaged
Inspect cable, replace if damaged
• Machines internal wiring damaged
Contact service centre
4. Machine does not cut
• Cutting objects too thick
See specification table for maximum cutting
thickness
• Blades worn
Get blades replaced or sharpened
Should you experience any problems at all with this
product or require spare parts, ring your nearest
authorized dealer.
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
The Ferm machines have been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
Cleaning
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt.
If the dirt does not come off use a soft cloth moistened
with soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please
contact your local Ferm dealer.
In the back of this manual you find an exploded view
showing the parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations.
Take your unwanted machines to your local Ferm-
dealer. Here they will be disposed off in an
environmentally safe way.
Ferm 5
