Bedienungsanleitung Ferm PDM1037S (Seite 6 von 108) (Alle Sprachen)

763702

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

• If you set the gear selection switch (8) to

position “1”, the drilling speed can be adjusted



• If you set the gear selection switch (8) to

position “2”, the drilling speed can be adjusted



• When the gear selection switch (8) cannot

switch easily between “1” and “2”, give the

chuck (1) a little spin by using your hands. This

will help the gears fall into the correct position

and makes switching the gears easier.

User tips

Always use the machine with the side handle

firmly anchored in place - you will not only work

with more comfort, you will also work with more

precision.

Caution: drilling bits and hammer drilling

bits can get very hot

Drilling and hammer drilling

• For large holes, for instance in very hard

concrete, start using a smaller bit for pilot

drilling first , then drill to nominal size.

• Hold the machine firmly with 2 hands. Be

aware the drill can jam and because of that

machine might suddenly turn (Especially when

drilling deep holes).

• Do not apply a lot of pressure on the machine,

let the machine do the work.

4. MAINTENANCE

Before cleaning and maintenance, always

switch off the machine and remove the

mains plug from the mains.

Clean the machine casings regularly with a soft

cloth, preferably after each use. Make sure that

the ventilation openings are free of dust and

dirt. Remove very persistent dirt using a soft

cloth moistened with soapsuds. Do not use any

solvents such as gasoline, alcohol, ammonia,

etc. Chemicals such as these will damage the

synthetic components.

Carbon brush

If the carbon brushes are worn, the carbon

brushes must be replaced by the customer

service department of the manufacturer or a

similarly qualified person.

Only use the correct original type of

carbon brushes.

If the supply cord is damaged, it must be replaced

by the manufacturer, its service agent or similarly

qualified persons in order to avoid a hazard.

Defects

The machine should be regularly inspected for

the following possible defects, and repaired if

necessary.

• Damage to power cord

 

• Short circuiting

• Damaged moving parts

WARRANTY

The warranty conditions can be found on the

separately enclosed warranty card.

ENVIRONMENT

Faulty and/or discarded electrical or

electronic apparatus have to be collected

at the appropriate recycling locations.

Only for EC countries

Do not dispose of power tools into domestic

waste. According to the European Guideline



Equipment and its implementation into national

right, power tools that are no longer usable must

be collected separately and disposed of in an

environmentally friendly way.

The product and the user manual are subject to

change. Specifications can be changed without

further notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm PDM1037S Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info