763903
5
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
5
EN
• Makesurethatthemaximumspeedforthe
accessory is larger than or the same as the
maximum speed of the machine. Refer to the
rating plate on the machine.
• Beforeuse,removeallnailsandothermetal
objects from the workpiece.
• Makesurethattheworkpieceisproperly
supported or fixed.
• Keepyourhandsawayfromtheworkpiece
during use.
• Neverputthemachinedownonatableora
workbench before it has been switched off.
Electrical safety
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
• Donotusethemachineifthemainscableor
the mains plug is damaged.
• Onlyuseextensioncablesthataresuitable
for the power rating of the machine with a
minimum thickness of 1.5 mm2.Ifyouusea
extension cable reel, always fully unroll the
cable.
Mains plug replacement (UK only)
Ifthemoulded3-pinplugattachedtotheunitis
damaged and needs replacing, it is important
that it is correctly destroyed and replaced by
anapprovedBS1363/5Afusedplugandthat
the following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- Thewirewhichiscolouredbluemustbe
connected to the terminal which is marked
with the letter N or coloured black.
- Thewirewhichiscolouredbrownmustbe
connected to the terminal which is marked
withtheletterLorcolouredred.
Technical specifications
PDM1040
Mains voltage 230 V~
Mains frequency 50 Hz
Power input 800W
No-load speed 0-3.000 /min
Impact rate 0-48.000 /min
Max. drill diameter
Wood 25 mm
Concrete 13 mm
Steel 10 mm
Protection class IP 20
Noise values
Sound pressure (LPA)88 + 3 dB(A)
Acoustic power (LWA)99 + 3 dB(A)
Vibration values
Drilling into metal 2,63 + 1.5 m/s2
Impact drilling into concrete 8,36 + 1.5 m/s2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN60745;itmaybeusedtocompareonetool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- usingthetoolfordifferentapplications,orwith
different or poorly maintainted accessories,
may significantly increase the exposure level
- thetimeswhenthetoolisswitchedofforwhen
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ferm PDM1040 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info