Bedienungsanleitung Ferm TJM1008 (Seite 2 von 40) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

510139

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

2 Ferm

TROLLEY JACK

Carfully read the instructions before you

use the trolley jack!

Contents

1. Machine data

2. Safety instructions

3. Operation

4. Maintenance

1. Machine data

Technical specification

Carrying capacity 2000 kg

Lifting height (min/max) 135/356 mm

2. Safety instructions

The following symbols are used in these

instructions for use:

Denotes risk of personal injury, loss of life

or damage to the machine in case of non-

observance of the instructions in this

manual.

Make sure the oil level is correct

Special safety rules

Non-observance of the following

instructions can cause personal injuries

and/or damage to the vehicle.

• Placethesaddleofthejackonlyinthespot

designed for this purpose. For the relevant

jackingpointspleaserefertoyourcar

instructions.

• Themaximumloadindicatedonthejackmust

never be exceeded.

• Thejackmustbeusedasaliftingdeviceonly.

• Alwaysplacethejackonahardandlevel

surface.

• Alwaysprotectthecarfromrollingaway.

Beforejackingupthecar,placechocksbehind

and in front of the wheels remaining on the

ground,ifnecessary.Putthecarinfirstgearor

put on the handbrake to further block the car.

• Makesuretoplacethejackinsuchawaythat

your hand is not underneath the car when

jackingitup.

• Makesurethejackishorizontal.

• Foryourownsafety,beforeworkingor

crawlingunderneaththecarjackupthecar

and support the shafts.

• Beforeusingtheshaftsupportsmakesure

they are in good condition.

3. Operation

Lifting

Turn the screw of the relief valve clockwise as far

aspossible.Thetrolleyjackisnowreadytolift.

Putthetrolleyjackhorizontallyonaflatsurface,

put the lever in the proper hole and start pumping

by moving the lever up and down.

Shaft supports

Afterjackingupthecartheshaftsupportsshould

be installed. Lower the car by turning the the

screwofthereleasevalveanticlockwise,untilthe

car rests on the supports. Never work under a car

whichonlyrestsonthetrolleyjack.

Lowering

Aftertheworkisfinished,thecarisliftedagain

until the shaft supports are clear. Remove the

shaft supports. Turn the screw of the relief valve

anticlockwise and the car will be lowered. The

further the screw is turned anticlockwise the faster

the car will be lowered.

4. Maintenance

Regular maintenance of your trolley jack

prevents problems!

• Onceamonththewheels,shaftsandpiston

rods should be lubricated with lubricating oil

and grease on the pivots of the lifting rods.

• Thetankcontaininghydraulicoilisaclosed

tank which usually does not require

maintenance.Whenfrequentlyused,butat

leastonceayear,theoilshouldbechanged.

For this purpose the top of the tank is fitted

with an oil drain plug.

Only hydraulic oil should be used for

refilling. Do not use engine or brake fluid.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm TJM1008 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info