778780
16
Zoom out
Zoom in
Vorherige Seite
1/77
Nächste Seite
7.2 Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera
ture to prevent overheating. The bottom
LED [1-12] indicates a fault.
LED lights up red Excessive temperature
Switch off the mobile dust extractor, let it
cool down.
Switch on the mobile dust extractor again
after approx. five minutes.
8 Working
8.1 Dust extraction
Extracting dry materials
Always use a filter bag.
8.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extractor stops automatically when
the maximum fill level is reached.
The bottom LED [1-12] lights up red.
Switch off the mobile dust extractor [1-10].
Open the locking clips [1-7] and remove the
top section of the machine.
Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
Switch off and empty the machine immedi
ately.
8.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
Do not blow off any dust!
The exhaust-air outlet offers the option of di
verting the exhaust air outside a building using
the suction hose.
Open the grille in front of the exhaust open
ing [1-8].
Insert the suction hose in the exhaust open
ing [1-8].
8.4 Changing the filter bag with minimal
dust
Open the locking clips and remove the top
section of the machine [2].
Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
Fit the top section of the machine and close
the locking clips.
8.5 Changing the filter element [6]
Pull out the used filter drawer [1-6].
Dispose of the used filter drawer in accord
ance with statutory regulations.
Insert the new filter drawer [1-6].
Order numbers for accessories, filters and
consumables in the Festool catalogue or
online at "www.festool.com".
Only use original Festool accessories and
consumables. Only accessories tested and
approved by Festool are safe and perfectly
adapted to the machine and application.
NOTICE
Damage to the motor
Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.
8.6 After finishing work
Switch off the mobile dust extractor and
pull out the mains plug.
Vacuum and wipe the inside and outside of
the mobile dust extractor to clean it.
Empty the dirt trap.
Wind up the mains power cable.
Place the mains power cable [4-1] in the
sealable depot. To do so, lay the power ca
ble through the recess [4-2].
Disconnect the suction hose [5-1] and fix it
to the mobile dust extractor using the suc
tion hose attachment [1-3].
Regularly clean the fill level sensors [7-1]
and check for damage.
English
16
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool CT 15 E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info