Bedienungsanleitung Festool CT11E - 1200W (Seite 7 von 54) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

574991

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

Please read the operating instructions and observe the safety precautions!

The specified illustrations can be found at the beginning of the operating instructions.

1 Technical data CT 11 E

Power consumption 350 - 1,200 W

Connected load to appliance plug socket max.:

EC 2,400 W

CH 1,100 W

GB 1,800 W

AUS 1,200 W

Volume flow (air) max., turbine 228 m

Vacuum max., turbine 23,000 Pa

Volume flow (air), typical value in operation 160 m

Vacuum, typical value in operation 18,000 Pa

Filter surface 14,000 cm²

Suction hose ø 27mm x 35 m

Sound pressure level in compliance with DIN 45 635 72 dB(A)

Container capacity 15 l

Dimensions L x W x H 671 x 390 x 350 mm

Weight 11.5 kg

Power cable length 7.5 m

Protection type IP X4

2 Specified use

The vacuum cleaners are designed for use as

specified for the aspiration and evacuation of non-

noxious dusts, dirt, sand, shavings etc..

The vacuum cleaners are designed as specified

for vacuuming water.

The vacuum cleaners are designed in accordance

with EN 60335-1 and EN 60335-2-69 for a higher

loading in industrial use.

2.1 Safety instructions

- Use only accessories approved by Festool (see

the Festool Catalogue).

- Do not suck in any sparks or hot chippings.

- With the exception of wood dust, do not suck in

any flammable or explosive dusts such as

magnesium, aluminium etc. Risk of explosion!

- Do not use to extract flammable or explosive

liquids (e.g. petrol, thinners). Risk of explosion!

- Do not use to extract aggressive liquids (e.g.

acids, alkalis, solvents)

- Remove plug from mains socket when not in use

and before maintenance work.

- Do not pull plug out of mains socket by its cable.

- Protect the cable against heat, oil and sharp

edges.

- Do not leave devices out in the rain.

- Check the plugs and cables regularly and have

them replaced by an expert if damaged.

- Do not lift or carry the devices by their handles

using a crane hook or lifting gear.

- For safety reasons, only operate the machine

using a totally earthed socket.

3 Appliance preparation and initial

operation

3.1 Electrical connection

Caution! The operating voltage shown on the rating

plate must correspond to the voltage of the mains

power supply. Make sure that the vacuum cleaner

is switched off when you plug the power cable in.

3.2 On/off switch (1.3)

In position 0 the vacuum cleaner is switched off and

the appliance plug socket (1.9) is dead.

Two modes of operation are possible:

a) Switch position MAN:

The cleaner motor starts immediately.

The appliance plug socket is dead.

Switch position and suction hose diameter must

match.

b) Switch position Auto:

The appliance plug socket is live. The cleaner motor

starts only when the tool connected to the appliance

plug socket is switched on.

Caution! Before turning the switch to the Auto

position, ensure that the tool connected to the

appliance plug socket is switched off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Festool CT11E - 1200W Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info