778794
21
Zoom out
Zoom in
Vorherige Seite
1/113
Nächste Seite
8.3 Extracting fluids
Remove the filter bag before absorbing fluids
(see section 7.8). The use of a special wet filter
is recommended.
The dust extraction stops automatically when
the maximum fill level is reached.
Dry main filter and container after wet suction
ing.
CAUTION
Escaping foam and fluids
Switch off the machine immediately and
empty the dirt trap.
8.4 After finishing work
Empty the mobile dust extractor after ev
ery use and clean if necessary.
Switch off the mobile dust extractor and
pull out the mains plug.
Wind up the mains power cable.
Empty the dirt trap.
Close off the extractor opening [1-2] using
the sealing plug [1-1].
WARNING
Hazardous dust
Damage to the respiratory passage
Wipe down the mobile dust extractor and
clean all accessories thoroughly using the
extractor (inside and out) before removing
from the working area.
Parts that you were not able to clean thor
oughly must be sealed in an airtight plastic
bag prior to transportation.
Wear a dust mask!
The machine shall be stored indoors on
ly.
Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
9 Maintenance and care
WARNING
Risk of injury, electric shock
Always pull the mains plug from the socket
before performing any servicing and main
tenance work.
All maintenance and repair work which re
quires the motor housing to be opened
must always be carried out by an author
ised service workshop.
WARNING
Electrostatic charges
Risk of explosion
Cleaning, maintenance and servicing work
may only be realised outside Zone 22.
Damaged safety devices and components must
be properly repaired or replaced in a recog
nised specialist workshop, unless otherwise in
dicated in the operating manual.
Customer service and repairs must only be
carried out by the manufacturer or service
workshops: Find the nearest address at:
www.festool.com/service
EKAT
1
235
4
Always use original Festool spare parts. Order
no. at: www.festool.com/service
Observe the following information:
Dust-related inspection (e.g. for filter dam
age, tightness of the machine and function
of the control devices) by the manufacturer
or an instructed person at least once a
year.
During maintenance and repair work, all
components that cannot be cleaned satis
factorily must be replaced. The old compo
nents must be sealed in impermeable plas
tic bags prior to disposal in compliance
with applicable regulations for this type of
waste.
Provided maintenance personnel or other
persons in the vicinity are not endangered,
the user must dismantle and clean the ma
chine prior to performing maintenance
work. Appropriate precautionary measures
include decontaminating the machine prior
to disassembly, making provisions for lo
cally filtered forced ventilation at the loca
tion of machine disassembly, cleaning the
maintenance area and appropriate person
al protective equipment.
English
21
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool CTL 48 E LE EC-B22 R1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info