778781
19
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
LED lights up red Excessive temperature
Switch off the mobile dust extractor, let it
cool down.
Switch on the mobile dust extractor again
after approx. five minutes.
7.3 Locking the brake [1A]
Raise the front of the mobile dust extractor
slightly.
Push down the brake [1-13] until it engages
into position.
Actuate the button [1-12] to release it.
7.4 SysDoc
WARNING
Risk of injury
Do not stand on the storage area of the
mobile dust extractor.
CAUTION
Risk of injury
Ensure that the T-Loc or the four SysDoc
locks are closed during transport.
A Systainer can be fastened to the storage
area [1-7] with the T-Loc lock [1-8]. Systainers
without T-Loc can be secured with the four Sys
Doc locks [1-3].
8 Working
8.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
Always use a filter bag!
Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: Room volume VR x air renewal rate
LW
8.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extractor stops automatically when
the maximum fill level is reached.
The bottom LED [1-18] lights up red.
Switch off the mobile dust extractor [1-11].
Open the locking clips [1-10] and remove
the top section of the machine.
Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
Switch off and empty the machine immedi
ately.
8.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
Do not blow off any dust!
The exhaust-air outlet offers the option of di
verting the exhaust air outside a building using
the suction hose.
Open the grille in front of the exhaust open
ing [1-14].
Insert the suction hose in the exhaust open
ing [1-14].
8.4 Cleaning the filter and filter bag
manually
In standby mode, press the MAN but
ton [1-17].
Set the suction power to the maximum set
ting [1-18].
Cover the suction hose with your hand while
at the same time briefly pressing down the
cleaning lever [1-16] three times.
English
19
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool CTL MINI I wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info