796183
24
Zoom out
Zoom in
Vorherige Seite
1/129
Nächste Seite
Always use original Festool spare
parts. Order no. at:
www.festool.co.uk/service
EKAT
1
235
4
To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
Clean the sanding tools after use.
8.1 Cleaning the dust screen
To prevent the power tool from overheating, the
dust screen [6-1] must be cleaned regularly on
both sides (see figure [6]).
Remove the dust screen. Use a screw
driver as a levering tool if necessary.
Extract the dust from the dust screen.
Insert the dust screen.
9 Storage
The packaged power tool can be stored in a dry
place without heating as long as the inside tem
perature does not fall below -5 °C.
The unpackaged power tool must only be stored
in a dry, enclosed space where the temperature
does not fall below +5 °C and where no extreme
temperature fluctuations can occur.
Store the insertion tools separately from the
power tool.
10 Accessories
Always use original Festool tools and accesso
ries. Using low-quality tools or accessories
from other manufacturers may increase the
risk of injury and seriously unbalance the ma
chine, decreasing the quality of the working re
sults and accelerating power tool wear.
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.
11 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
In accordance with the European Directive on
waste electrical and electronic equipment and
implementation in national law, used power
tools must be collected separately and handed
in for environmentally friendly recycling.
Information on collection points for proper dis
posal can be found at www.festool.co.uk/
recycling.
Information on REACH: www.festool.co.uk/
reach
12 General information
12.1 Information on data privacy
The power tool contains a chip which automati
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
12.2 Information about Bluetooth®
As soon as the tool is connected to the mobile
device via Bluetooth® and the secure connec
tion has been authorised, the tool will connect
automatically to the mobile device from this
point onwards.
The Bluetooth® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
English
24
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool RG 130 ECI wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info