Bedienungsanleitung Fiat 500 - 2011 (Seite 16 von 218) (Englisch)

638002

Zoom out

Zoom in

Vorherige Seite

1/218

Nächste Seite

capable of detecting environmental light conditions

and adjusting the brightness of the instruments

accordingly.

The brightness of the instrument panel may

therefore change while travelling following an event

causing a switch from “day” to “night” conditions (or

vice versa) in the passenger compartment (e.g. in a

tunnel, on avenues in shadows, under flyovers, etc.).

This function is available, with the dipped headlamps

on and in night-time conditions, to adjust the

brightness of the instrument panel, buttons, sound

system display and automatic climate control display.

For versions/markets, where provided, during the

daytime, and with the dipped headlamps on, the

instrument panel, buttons and sound system and

automatic climate control displays are set to

maximum brightness.

To adjust the light intensity, proceed as follows:

❒ press the MENU ESC button briefly to make the

display flash the previously stored level;

❒ press button + or – to adjust the brightness level;

❒ press the MENU ESC button briefly to return

to the menu screen or give the button a long press

to return to the standard screen without storing.

Speed Beep (Speed limit)

This function is used to set the car speed limit (km/h

or mph); the driver is immediately alerted when

this limit is exceeded (see section “Warning lights

and messages”).

To set the desired speed limit, proceed as follows:

❒ briefly press the MENU ESC button to make

the display show the words (Speed Beep);

❒ press button + or – to select speed limit activation

(On) or deactivation (Off);

❒ if the function is on, press + or – to select the

required speed limit and then press MENU ESC to

confirm.

Note Setting is possible between 30 and 200 km/h,

or 20 and 125 mph, according to the previously

set unit. See the "Measurement unit adjustment

(Measurement unit)" paragraph described below. The

setting will increase/decrease by five units each time

button +/- is pressed. Hold down the button +/-

to increase/decrease the setting rapidly. Complete

the setting by briefly pressing the button when

you approach the required value.

❒ press the MENU ESC button briefly to return to

the menu screen or give the button a long press

to return to the standard screen without storing.

To cancel the setting, proceed as follows:

❒ press the MENU ESC button briefly to make the

display flash (On);

❒ press button – : (Off ) will flash on the display;

❒ press the MENU ESC button briefly to return to

the menu screen or give the button a long press

to return to the standard screen without storing.

GETTING TO

KNOW YOUR CAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fiat 500 - 2011 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Fiat 500 - 2011

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info