Bedienungsanleitung Fiat 500 X - 2014 (Seite 200 von 228) (Englisch)

637823

200

Zoom out

Zoom in

Vorherige Seite

1/228

Nächste Seite

Once sufficient data is available, the

indices will have 5 colours depending

on the evaluation: dark green (very

good), light green, yellow, orange and

red (very bad).

"Current route index" refers to the entire

value calculated in real time based on

the average of the described indices. It

represents eco-friendliness of the

driving style: from 0 (low) to 100 (high).

In the event of extended inactivity the

display will show the average of the

indices until that moment (the "Average

index"), then the indices will be

coloured again in real time as soon as

the vehicle is restarted.

To check the data average of previous

route (the "route" starts when the

ignition key is turned to MAR and stops

when it is turned to STOP), select the

"Previous route" button.

The details of the previous trip can also

be displayed by pressing the "Details"

button, in which journey duration (time

and mileage) and average speed will be

reported.

Trip data storage and

transfer

The trip data can be stored in the

system memory and transferred

through a properly configured USB

memory stick or the App Uconnect™.

This allows you to display the history

of the collected data, showing the

complete analysis of the trip data and

of your driving style.

Further information is available at

www.DriveUconnect.eu.

IMPORTANT Do not remove the USB

memory stick nor unpair the

smartphone and the App Uconnect™

before the system has downloaded

the data, since these could be lost.

During the transfer of data to the

devices, messages may appear on the

radio display to guide the user correctly

through the operation; follow these

instructions. These messages are only

displayed with the ignition key at STOP

and when a delay in the system

switching off is set. The data are

automatically transferred to the devices

when the engine is switched off. The

data transferred are deleted from the

system memory. You can choose

to store the trip data or not, by pressing

the "Settings" button and by setting

the storage activation and the USB or

Cloud transfer mode.

When the USB memory stick is full, the

dedicated messages are shown on

the radio display.

When the eco:Drive™ data is not

transferred to USB memory stick for a

long time, the internal memory of the

Uconnect™ system may be

exhausted. Follow the instructions given

by the messages on the radio display.

my:Car

my:Car allows you to keep the

condition of your vehicle always under

control.

my:Car can detect malfunction in real

time and inform the user about the

expiry of the servicing interval. Press

the "my:Car" button to interact with the

application.

The display will show a screen with the

"care:Index" section, which provides

all the detailed information about the

status of the vehicle. Press the "Active

warnings" button to show (if present)

the details of the vehicle's faults which

caused a warning light to switch on.

The vehicle status can be see both on

www.DriveUconnect.eu or through

the App Uconnect™.

198

MULTIMEDIA

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fiat 500 X - 2014 Seite 200

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Fiat 500 X - 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info