Bedienungsanleitung Finlux 42S7010 (Seite 34 von 42) (Englisch)

500526

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

English - 33 -

Tips

Screen Care: Clean the screen with a slightly damp,

soft cloth. Do not use abrasive solvents as they may

damage the coating layer of the TV screen. For your

safety, unplug the mains plug when cleaning the set.

When moving the TV, hold it properly from the bottom

of the unit.

Image Persistence: Please note that ghosting may

occur while displaying a persistent image. On LED

TVs’ image persistence may disappear after a short

time. Try turning the TV off for a while.

To avoid this, do not leave the screen in still picture

for extended periods.

No Power: If your TV system has no power, please

check the main power cable and connection to the

mains socket outlet.

Poor Picture: Have you selected the correct TV

system? Is your TV set or house aerial located too close

to a non-earthed audio equipment or neon lights, etc.?

Mountains or high buildings can cause double pictures

or ghost images. Sometimes you can improve the

picture quality by changing the direction of the aerial.

Is the picture or teletext unrecognisable? Check if you

have entered the correct frequency. Please retune the

channels. The picture quality may degrade when two

peripherals are connected to the TV at the same time.

In such a case, disconnect one of the peripherals.

No Picture: Is the aerial connected properly? Are the

plugs connected tightly to the aerial socket? Is the

aerial cable damaged? Are suitable plugs used to

connect the aerial? If you are in doubt, consult your

dealer. No Picture means that your TV is not receiving

a transmission. Have you selected the correct button

on the remote control? Try once more. Also make sure

the correct input source has been selected.

Sound: If you cannot hear any sound, check to see

if the button has been pressed. If sound is coming

from only one speaker, check if the balance has been

set to one extreme.

Remote Control: Your TV no longer responds to the

remote control. Perhaps the batteries are exhausted.

If so you can still use the local buttons on the TV.

Input Sources: If you cannot select an input source,

it is possible that no device is connected. Check

the AV cables and connections if you have tried to

connect a device.

Recording Unavailable: To record a programme, you

should ﬁ rst connect a USB disk to your TV while the

TV is switched off. You should then switch on the TV to

enable recording feature. Otherwise, recording feature

will not be available. If you cannot perform recording,

try switching off the TV and then re-inserting the USB

device while the TV is switched off.

USB Is too Slow: If “USB is too slow” message is

displayed on the screen while starting a recording,

try restarting the recording. If you still get the same

error, it is possible that your USB disk does not meet

the speed requirements. Try connecting another

USB disk.

01_MB69_[GB]_DVB-T_5103UK_42912LED_GOLD17_10076863_50208403.indd 33 07.02.2012 11:10:17

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Finlux 42S7010 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info