Bedienungsanleitung Finnlo 3272 Loxon (Seite 26 von 46) (Holländisch)

528513

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

You can set a DRINK FIT function during the setting of your personal datas. You can choose between OFF, 15, 20, 25

and 30minutes. The symbol will be shown for 3 seconds with an beep in the matrix, it doesn´t matter in which program

you are.

5.2.2 Explanation of the symbols and need to know

The symbol demand you to begin to pedal. the set values will be conrmed and you start your exercise.

A) Pedalling

B) Drink FIT

D) Setting values

Target values: After achieving the target values, there will be a beep and the computer will stop counting. The monitor will show the

average and trip values. To continue your exercise, you have to reactivate the computer by pressing the DELETE button.

Attention: Except the heartrate value, you can set only one further value. If you set another value, the already set value will be set to

OFF. To start your exercise, beginn to pedal, after you have set the target value.

E) HI-Watt

In PROGRAM-Mode, you can set the max Watt resistance which will be reached during your exercise. All other Watt values will be

calculatated accordingly to the max value.

F) Recovery

After you nished your exercise press RECOVERY and stop pedalling. The computer will measure the heartrate for the next 60 seconds. If

the dierence between the starting and end heartrate is around 20%, you will get the grade F1 (very good).

C) Waking up the computer from the snooze mode

To reactivate the computer from the snooze mode, press any button, please. A pedalling has no function in this mode.

H) AGE

Needed for max heartrate calculation.

G) Increasing of the resitance level during HRC -Mode

The resistance will be increase every 30 seconds for one level, till you reach a heart rate value, which is 5 beats lower than your target. The

resistance will stay at this level for 1 minute. If there is no further heartrate change, the resistance will increase again. If the actual heartrate

is for 5 seconds higher than your target, the resistance will decrease immediately for two levels and than every 20 seconds for one level, till

your actual heartrate is lower than the target. If it is lower than the target heartrate, the resistance will increase again.

For IND: You can set a heartrate zone. The increasing is following the same procedure like above mentioned. Pay attention, that if your

actual heartrate cannot be under the LO limit, the resistance will not increase anymore. You have to stop your exercise and set new targets!

The arrows in the heartrate windows indicate, that the resistance cannot be increased or decreased and so you have to pedal slower (arrow

down) or pedal faster (arrow up).

If your actual heartrate is ve beats lower than the set target, the circle between the two arrows start to blink. It indicates, that you are

reaching your target value. If your actual heartrate is higher than the high limit, there will be a beep and the actual heartrate starts blinking.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Finnlo 3272 Loxon Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Finnlo 3272 Loxon

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info