Bedienungsanleitung First Alert OneLink - 1042136 (Seite 8 von 28) (Englisch)

795123

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Where Not to Install

Do NOT locate this Smoke/CO Alarm:

• In garages, furnace rooms, crawl spaces and unﬁnished attics. Avoid extremely dusty, dirty or greasy areas.

• Where combustion particles are produced. Combustion particles form when something burns. Areas

to avoid include poorly ventilated kitchens, garages, and furnace rooms. Keep units at least 20 feet (6

meters) from the sources of combustion particles (stove, furnace, water heater, space heater) if possible.

In areas where a 20 foot (6 meter) distance is not possible – in modular, mobile, or smaller homes, for

example – it is recommended the Smoke Alarm be placed as far from these fuel-burning sources as

possible. The placement recommendations are intended to keep these Alarms at a reasonable distance

from a fuel-burning source, and thus reduce “unwanted” alarms. Unwanted alarms can occur if a Smoke

Alarm is placed directly next to a fuel-burning source. Ventilate these areas as much as possible.

• Within 5 feet (1.5 meters) of any cooking appliance. In air streams near kitchens. Air currents

can draw cooking smoke into the smoke sensor and cause unwanted alarms.

• In extremely humid areas. This Alarm should be at least 10 feet (3 meters) from a shower, sauna,

humidiﬁer, vaporizer, dishwasher, laundry room, utility room, or other source of high humidity.

• In direct sunlight.

• In turbulent air, near ceiling fans or open windows. Blowing air may prevent CO/smoke from reaching

the sensors.

• In areas where temperature is colder than 40˚ F (4.4˚C) or hotter than 100˚ F (37.8˚C). These areas include

non air conditioned crawl spaces, unﬁnished attics, uninsulated or poorly insulated ceilings, porches,

and garages.

• In insect infested areas. Insects can clog the openings to sensing chamber.

• Less than 12 inches (305 mm) away from ﬂuorescent lights. Electrical “noise” can interfere with the sensor.

• In “dead air” spaces. See below for additional information.

Installing Smoke/CO Alarms in Mobile Homes

“Dead air” spaces may prevent smoke from reaching the Smoke/CO Alarm. To avoid dead air spaces, follow

installation recommendations below.

• On ceilings, install Smoke/CO Alarms as close to the center of the ceiling as possible. If this is not possible,

install the Smoke/CO Alarm at least 4 inches (102 mm) from the wall or corner.

• For wall mounting (if allowed by building codes), the top edge of Smoke/CO Alarms should be placed

between 4 inches (102 mm) and 12 inches (305 mm) from the wall/ceiling line, below typical“dead air”spaces.

• On a peaked, gabled, or cathedral ceiling, install ﬁrst Smoke/CO Alarm within 3 feet (0.9 meters) of the

peak of the ceiling, measured horizontally. Additional Smoke/CO Alarms maybe required depending on

the length, angle, etc. of the ceiling’s slope. Refer to NFPA 72 for details on requirements for sloped

or peaked ceilings.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

First Alert OneLink - 1042136 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info