Bedienungsanleitung First Degree VORTEX VX-3 FLUID ROWER (Seite 22 von 32) (Englisch)

671443

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Operation Instructions

INITIAL WATER TREATMENT

Add 1 x Water Treatment Tablet per full tank. DO NOT, UNDER ANY CIRCUMSTANCE, USE A WATER

TREATMENT TABLET OTHER THAN THOSE SUPPLIED WITH YOUR UNIT. Your unit purchase includes 4 x

Water Treatment Tablets, which is sufficient for several years of use. To purchase additional chlorine

tabs, please consult your nearest regional dealer/distributor or check our website at

www.firstdegreefitness.com

a) Filling requires a large bucket (not Supplied) and the supplied

water Funnel and hose[5]. Filling will take approximately 8

liters of water.

b) Open the yellow fill plug on the back of the tank and insert

hose (rotating the impeller slightly may be necessary to allow

the hose to pass). Note: In areas where tap water quality is

known to be poor, FDF recommends the use of distilled water.

c) Move the Tank Adjuster Handle to Level 20 and begin filling.

Do not fill the tank higher than the level indicator on the front

of the clear shell.

d) Once filling is complete follow the water treatment procedure

below, then replace the tank plug.

CAUTION

Use a drop cloth under

the tank when filling to

avoid damage floor or

carpet.

Do not fill past the

calibration mark as

indicated on the tank

level sticker or water

spillage may occur.

WARNING

Impeller blades are

sharp! Do not Place

fingers in tank to

adjust impeller position.

It is recommended to

use the end of the hose

Should the impeller

require adjustment.

REQUIRED

Funnel and Hose [5].

Note: The Lower Black Tank Plug is Permanently Sealed.

Yellow Tank Plug

Filling Hose and Funnel

Tank Filling and Water Treatment

Long Term Water Treatment:

Do not use any water treatment other than the tablets supplied with this unit. For replacement tablets,

contact your local First Degree Fitness distributor.

Water treatment schedules for the FLUID ROWER will vary according to the fluid tanks exposure to

sunlight, but expect 8-12 months near a bright, sunlit window and 2 years or more for a darker location.

At the point of finding the water slightly cloudy, add a Water Treatment Tablet.

Long Term Water Treatment and Basic Operation

Resistance:

Resistance is determined by the Level Indicator on the front of the tank.

Level 1 indicates lightest resistance and level twenty the heaviest. Allow

three to four strokes, after moving the Level Indicator, for the new level to

be achieved. Note computer level must be changed to provide accurate input

at each individual tank level. Consult your IPM computer manual (included) for

details.

Vertical Storage:

The FLUID ROWER can easily be stored in a vertical position. For safety,

choose a suitable location, such as a corner of a room. It is recommended

that something soft (such as carpet or a small towel) be placed under the

rowing pulley of the unit to avoid chipping or floor damage. Note: Move with

caution as the unit is heavy. Pick up from back and pull at 45 degree angle.

Level Indicator

CAUTION: It is strongly recommended that a drop cloth be used under the fluid tank whenever the

tank plug is opened for water treatment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

First Degree VORTEX VX-3 FLUID ROWER Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info