Bedienungsanleitung Florabest FAAS 10.8 A1 - IAN 57384 (Seite 40 von 44) (Deutsch, Italienisch)

722882

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

40 GB

Before using / Start-up / Maintenance and Cleaning… / Safety notices for chargers / Working instructions for sawing / Before using

Secure the work piece. Use clamps or a

vice to ﬁrmly hold the work piece. This results

in a safer grip than with your hand.

Wait for the power tool to stop before

putting it down. The tool being used could

catch, resulting in losing control over the pow-

er tool.

Lock the on/off switch to the off posi-

tion before working on the power tool

(e.g. maintenance, tool change, etc.),

and when transporting or storing. Risk

of injury if the on/oﬀ switch is accidentally acti-

vated.

Protect the power tool from heat, e.g.

also from continuous sunlight, fire,

water and moisture. Risk of explosion.

Wear the dust mask when using the tool.

If the mains power cable of this appliance is

damaged, it must be replaced by the manufac-

turer or its service department, or a similarly

qualiﬁed person to prevent hazards.

Safety notices for chargers

Persons (including children) who lack the know-

ledge or experience to use the tool or whose

physical, sensory or intellectual capacities are

limited must never be allowed to use the tool

without supervision or instruction by a person

responsible for their safety. Always supervise

children to ensure they do not play with the tool.

The charger is only suitable for

indoor use.

Working instructions for sawing

Check the material you wish to cut for foreign

objects such as nails, screws, etc. and remove

these.

Immediately switch oﬀ the tool if the saw blade

is jammed. Spread the previously cut slit with a

suitable tool and remove the sabre saw.

Saw the material with an even feed motion.

Original accessories / tools

Use only the accessories specified in

the operating instructions. Using tools or

accessories other than those recommended in

the operating instructions could result in injury.

Information about saw blades

You may use any saw blade with

" (12.7 mm)

universal shaft. Saw blades in various lengths opti-

mised for any purpose are available from your retailer.

Before using

Removing / charging / inserting

the battery pack

Note: The battery is partly charged at the time of

delivery. Charge the battery before use. Li-Ion bat-

teries can be charged at any time without reducing

the life. Interrupting the charging process does not

damage the rechargeable battery.

1. To remove the battery pack

press the release

buttons

and slide the battery pack

out

of the tool.

2. Insert the rechargeable battery pack

into

the rapid charger

3. Insert the mains plug into the mains socket. The

status LED

will light up red.

4. The green status LED

shows charging is

completed and the battery pack is

ready

for use.

5. Slide the battery pack

into the tool.

Checking the battery charge

Press the test button

to check the battery

condition (see Fig. A).

The battery LED

indicates the condition and

the remaining charge as follows:

RED / ORANGE / GREEN = maximum

charge / power

RED / ORANGE = medium charge/ power

RED = low charge – recharge battery

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Florabest FAAS 10.8 A1 - IAN 57384 Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Florabest FAAS 10.8 A1 - IAN 57384

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info