Bedienungsanleitung Florabest FBKS 4014 (Seite 11 von 20) (Englisch)

531719

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

S If the brake is already activated, it is disen-

gaged by pulling thefront hand guard back

toward the front handle as far as possible.

S When cutting with the saw, the chain brake

must be disengaged.

Engaged

Disengaged

Braking function control

WARNING: Thechain brake must be

checked several times daily . The engine

must berunning when performing this proce-

dure. This is theonly instance when the saw

should be placed on the ground with the en-

gine running.

Place the saw on firm ground. Grip the rear

handle with your right handandthe front han-

dle with your left hand. Apply full throttle by

fully d epressing the throttle trigger. Activate

the chain brake by turning your left wrist

against the hand guard without releasing

your grip around the front handle. The chain

should stop immediately.

Inertia activating function control

WARNING: When performing the fol-

lowing procedure, the engine must be turned

off.

Grip the rear handle with your right hand and

the front handle with your left hand. Hold the

chain saw approximately 14” (35 cm) above

a stump or other wooden surface. Release

your grip on the front handle and use the

weight of the saw to let the top of the guide

bar fall forward and contact the stump.

When the tip of the bar hits the stump, the

brake should activate.

CUTTING METHODS

IMPORTANT POINTS

WARNING: Occasionally, wood chips

get stuck in the clutch cover causing the chain

to jam. Always stop engine before cleaning.

S Check chain tension before first use and

after 1 minute of operation. See CHAIN

TENSION in the ASSEMBLY section.

S Cut wood only . Do not cut metal, plastics,

masonry , n on-wood b uildin g mat erials, etc.

S The bumper spike may be used as a pivot

when making a cut. Drive in the bumper

spike of the chain saw directly behind the in-

tended hinge and pivot the saw around this

point. The bumper spike rolls aga inst the

trunk.

S Stop the saw if the chain strikes a foreign

object. Inspect thesaw andrepair parts as

necessary.

S Keepthe chain out ofdirtand sand. Even a

small am ount of d irt will quickly dull a chain

and increase the possibility of kickback.

S Practice cutting a few small lo gs using the

following techniques to get the “feel” of us-

ing your saw b efore you begin a major

sawing o peration.

S Squeeze the throttle trigger and allow

the engine to reach full speed before

cut ting.

S Begin cutting w ith the saw frame

against the log.

S Keep the engine at full speed the en-

tire time you are cutting.

S Allow the chain to cut for you. Exert

only light downward pressure.

S Release the throttle trigger as soon

as the cut is completed, allowing the

engine to idle. If you run the saw at

full throttle without a cutting load, un-

necessary wear can occur.

S To avoid losing control w hen cut is

complete, do not put pressure on saw

at end of cut.

S Stop the engine before setting the saw

down.

TREE FELLING TECHNIQUES

WARNING: Do notcut nearbuildings

or electrical wires if you do not know the di-

rection of tree fall, at night since you will not

be able to see well, or during bad weather

such as rain, snow, or strong winds. as fall is

unpredictable.

Carefully plan your sawing operation in ad-

vance. You need a clear area all around the

tree so you can have secure footing. Check

for broken or dead branches which can fall

on you causing serious injury.

Natural conditions that can cause a tree to

fall in a particular direction include:

S The wind direction and speed.

S The lean of the tree. The lean of a tree

might not be apparent due to uneven or

sloping terrain. Use a plumb or level to de-

termine the direction of tree lean.

S Weight and branches on one side.

S Surrounding trees and obstacles.

Look for decay and rot. If the trunk is rotted,

it can snap and fall toward the operator.

Make sure there is enough room for the tree to

fall. Maintain a distance of

2-1/2 tree lengths

from the nearest person or other objects. En-

gine noise can drown out a warning call.

Remove dirt, stones, loose bark, nails, staples,

and wire from the tree where cuts are to be

made.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Florabest FBKS 4014 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Florabest FBKS 4014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info