539572
66
Zoom out
Zoom in
Vorherige Seite
1/70
Nächste Seite
GB
- 68 -
9. Storage and transport
9.1 Storage
Important: Never put the equipment into sto-
rage for longer than 30 days without carrying out
the following steps.
Storing the equipment
If you intend to store the equipment for longer
than 30 days, it must be prepared accordingly.
Otherwise the fuel still remaining in the carburetor
will evaporate and leave a rubbery sediment.
This can cause problems when starting up the
equipment and may require expensive repairs.
1. Slowly remove the fuel tank cap to release
any pressure that may have formed in the
tank. Carefully empty the tank (6).
2. To remove the fuel from the carburetor, start
the engine and let it run until the equipment
stops.
3. Leave the engine to cool (approx. 5 minutes).
4. Remove the spark plug (see 8.3).
5. Add one teaspoon of 2-stroke engine oil into
the combustion chamber. Slowly pull the star-
ter cord several times to apply a layer of oil
to all internal components. Fit the spark plug
again.
Note: Store the equipment in a dry place and
far away from possible ignition sources such as
an oven, a gas-fi red hot water boiler, a gas-fi red
dryer, etc.
Putting the equipment back into opera-
tion
1. Remove the spark plug (see 8.3).
2. Quickly tug on the starter line to remove ex-
cess oil from the combustion chamber.
3. Clean the spark plug and check that the elec-
trode gap is correct, or insert a new spark
plug with the correct electrode gap.
4. Prepare the equipment for operation.
5. Fill the tank with the relevant mixture of fuel
and oil. See the section “Fuel and oil”.
9.2 Transport
To transport the equipment, empty the petrol tank
as described in the section “Storage”. Clean
coarse dirt off the equipment with a brush or hand
brush. Dismantle the steady grip and the long
hande as described in section 6.1.1 and 6.1.2.
10. Cleaning
Always switch off the equipment and pull out the
spark boot plug before carrying out any cleaning
work.
The equipment should be cleaned thoroughly
every time after it has been used. This applies
particularly to the cutting tool and the guard
hoods.
Keep the air vents and the motor housing free
of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it down
with compressed air at low pressure.
It is easiest to remove dirt and grass immedia-
tely after mowing.
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive
to the plastic parts in the equipment. Ensure
that no water can get into the interior of the
equipment.
11. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materi-
als in this packaging can be reused or recycled.
The equipment and its accessories are made of
various types of material, such as metal and plas-
tic. Defective components must be disposed of as
special waste. Fuel and oil must be disposed of
only at special refuse collection centers. Ask your
dealer or your local council.
Anleitung_3401991_LB2.indb 68Anleitung_3401991_LB2.indb 68 24.02.12 14:0924.02.12 14:09
66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

florabest-fbs-43-a1

Suche zurücksetzen

  • Welches Benzingemisch kommt in den Freischneider Flora Best FBS 43 A1 Eingereicht am 28-8-2021 13:09

    Antworten Frage melden
  • Motorsense geht bei letzten Drittel der Tankfüllung aus Eingereicht am 23-5-2021 13:53

    Antworten Frage melden
  • wie wird die Benzinleitung eingebaut bei der Motorsense Florabest FBS 43 A1 Eingereicht am 1-4-2021 18:57

    Antworten Frage melden
  • Die Sense gegt nicht an .Zündkerze wurde erneuert. Eingereicht am 15-7-2020 20:05

    Antworten Frage melden
  • wie mus ich fbs 43 a1 betanken ? mit normalbenzien oder gemisch wen gemisch was für ein mischungsferhältnis Eingereicht am 20-3-2020 13:20

    Antworten Frage melden
  • Wie wechselt man die Starterglocke beim Freischneider FBS 43 A1 Eingereicht am 25-9-2018 12:04

    Antworten Frage melden
  • FBS 43 A1 Vierkantaufnahme ist verloren gegangen, wie ist das teil zu montieren Eingereicht am 15-7-2018 12:43

    Antworten Frage melden
  • Florabest Benzin Sense FBS 43 A1
    IAN: 65376
    S/N: EB035590
    hergestellt: 05/2011
    Welchen Typ habe ich?
    LB2 3401991
    11021
    oder
    LB2 3401991
    11032

    DANKE Eingereicht am 14-7-2018 17:33

    Antworten Frage melden
  • Was für Öl verwendet man für die die Wasserpumpe Florabest Eingereicht am 14-7-2018 10:51

    Antworten Frage melden
  • Ja ich würde den Faden gern ab machen und das Metallblatt dran machen. Dort ist ein kleines Loch ?
    Eingereicht am 21-6-2018 14:36

    Antworten Frage melden
  • Was führ Sprit benutzt man für die Segen von fbs43a1? Eingereicht am 15-6-2018 12:41

    Antworten Frage melden
  • Gibt es den Gasgriff als Ersatz für die Motorsense Florabest FBS 43 A1 Eingereicht am 17-5-2018 12:46

    Antworten Frage melden
  • Die sense geht nicht an, Zündkerze wurde erneuert frisches bezingrmisch ist frisch Eingereicht am 14-5-2018 18:31

    Antworten Frage melden
  • Motorsense geht aus sobald der Schoke geöffnet wird. Abdichtung (Schaumgummi)wurde erneuert. Eingereicht am 5-5-2018 14:50

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Florabest FBS 43 A1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info