Bedienungsanleitung Florabest FLB 3000 A1 - IAN 109790 (Seite 16 von 108) (Englisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

674626

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

forwards directing the nozzle at the debris

to be cleared.

Alternatively hold nozzle just above the

ground and swing the machine from side

to side, moving forwards and directing the

nozzle at the debris to be cleared. Blow the

debris into a convenient heap then use the

vacuum function to collect the debris.

Vacuum mode

Inspect the area to be worked before start-

ing. Remove any objects or debris that

could be thrown, jammed or become en-

tangled in the Vacuum-Blower.

Select the vacuum function using the se-

lector lever on the side of the machine

and switch on. With the Vacuum-Blower

resting on its wheels move the Vacuum-

Blower forwards directing the nozzle at

the debris to be collected. Alternatively

with the Vacuum-Blower held just above

the ground swing the machine from side

to side, moving forwards and directing the

nozzle at the debris to be collected. Do not

force the nozzle into the debris as this will

block the suction tube and reduce the ef-

ficiency of the machine.

Organic materials such as leaves contain a

large amount of water that can cause them

to stick to the inside of the suction tube. To

reduce sticking the material should be left

for a few days to dry out.

Adjust the front handle (fig. 12-14)

• Press the side adjustment button (12.1)

(fig. 12).

• Now set the handle to the desired posi-

tion (13.1) (fig. 13).

• Release the adjustment button, the front

handle latches into position and is locked

(fig. 14).

Using the leaf rake

Working with the leaf rake (fig. 15)

• Rotate the knob by 90 and slide it down-

wards (15.1)

• To fasten in place rotate the knob by 90°

again (15.2)

• The rake is now fastened in place (15.3)

Working without the leaf rake (fig. 16)

• Rotate the knob by 90° and slide it up-

wards (16.1)

• To fasten in place rotate the knob by 90°

again (16.2)

• The rake is now disabled (16.3)

Cleaning flap (fig. 17-18)

If the device is no longer operating cor-

rectly due to clogging or blockages, open

the cleaning flap as follows:

• Remove mains plug

• Loosen the screw (17.1) by turning coun-

ter-clockwise.

• Open the cleaning flap (18.1) and fold

up the cover (fig. 18).

• Carefully remove residue or blockages

on the impeller.

• Check whether the impeller turns easily

and is in fault-free condition

Important

If the cleaning flap is not closed and

correctly screwed down the device

cannot be operated.

Cleaning and Storage

Make sure that all nuts, bolts and screws

are tight and that the guards are fitted

correctly.

All damaged and worn parts should be

replaced in order to maintain the Vacuum-

Blower in a safe working condition.

Never leave material in the Vacuum-Blow-

er or the debris collection bag. This could

be dangerous when starting the Vacuum-

Blower.

After use the Vacuum-Blower should be

thoroughly cleaned.

Ensure that the Vacuum-Blower is switched

off and disconnected from the mains sup-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Florabest FLB 3000 A1 - IAN 109790 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info