733021
199
Zoom out
Zoom in
Vorherige Seite
1/264
Nächste Seite
197
EN
Source: Shimano
®
techdocs
Get thorough instructions from your
FLYER specialist dealer and practise
changing the wheels and tyres under
their supervision if you plan to repair
your own at tyres. The system must be
switched off and the battery must be re
-
moved before changing a tyre or wheel.
You need the following equipment to repair a tire
puncture:
Plastic tire lever
Patches
Rubber cement
Sandpaper
Open-ended spanner or wrench (for wheels
without quick release skewers)
Air pump
Spare tube
Your FLYER is equipped with a disc brake. This
way, you can remove the wheel without doing any
further preparation.
Please note: when tting the wheel, the disk must
be slotted between the brake linings of the brake
calliper and ultimately be centred without contact.
1. Removing the wheel
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your bike has hexagonal bolts, then loosen
them in anti-clockwise direction with a tting
ring spanner or box-end wrench.
You can then remove the front wheel according to
the steps listed above.
The following ap
-
plies for rear
wheels:
If your FLYER
uses a derailleur
gear system, change gear to the smallest
sprocket. In this position, the rear derailleur
poses the least hindrance in removing the
wheel.
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your FLYER has hex nuts, loosen these with
a suitable spanner anti-clockwise.
Pull the rear derailleur backwards somewhat.
Lift the bike slightly.
Lightly strike the wheel from above with the
palm of the hand.
Take the wheel out of the frame.
Types of valve on bicycle tubes
2. Removing the tyre and inner tube
Unscrew the valve cap, the fastening nut and
possibly the cap nut from the valve.
Release all of the remaining air from the inner
tube.
Insert the tyre lever opposite the valve on the
inside of the tyre.
Insert the second tyre lever approx. 10 cm from
the rst, between the rim and tyre. Lift the tyre
bead over the edge of the rim.
Repeat this lifting action around the wheel until
the entire tyre is free.
Remove the inner tube from the tyre.
3. Change the inner tube
Switch the inner tube for an intact one.
Tubular tires and tubeless tires must be
changed according to the tires and rims’
manufacturers instructions.
4. Reassembling the tyre and inner tube
Please avoid allowing foreign bodies in-
side the tyre. Ensure that the inner tube
does not have any folds and is not
squashed.
Ensure that the rim tape covers all spoke
nipples and does not have any damage.
Sclaverand
199

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Flyer Mountain - Bosch 2019 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info