Bedienungsanleitung Flyer Mountain - Bosch 2019 (Seite 205 von 264) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

733021

205

Zoom out

Zoom in

Vorherige Seite

1/264

Nächste Seite

203

16.1 Riding with additional load

Luggage carrier | riding with luggage

FLYER E-MTBs are generally not approved for

use with luggage racks.

As an exception, certain models have a specially

adapted FLYER luggage rack.

16.2 Carrying children

The safe transport of children is the responsibility

of the cyclist. Biketec AG cannot be held liable in

connection with the transport of children and the

resulting risks.

FLYER E-MTBs are not allowed to be ridden car

rying a child seat.

Bicycle trailers and child trailers

Your FLYER e-MTB is not approved for use with

a trailer.

16.3 Roof and rear carrier on a car

Only use rear carriers which satisfy the

applicable national legislation for trans

porting your bike by car. The use of rear

carriers may lead to accidents. Trans

porting or xing the bike inappropriately

could cause damage to your car, mount

or E-MTB.

• Adjust your driving according to the

weight of your rear carrier.

• When transporting your bike, you

should check regularly that your

FLYER e-bike is secure and safely

fastened.

• If your FLYER falls out of the carrier,

it can cause serious accidents.

• Avoid transporting your FLYER on the

roof of a vehicle and always cover the

motor with a rain protector cover to

prevent it from becoming damaged.

It is strongly recommended to cover

the whole bicycle with a rain protec

tor cover.

• Please note that loose parts, such as

tools, luggage and tool bags, child

seats, air pumps etc. could fall off dur

ing transport. This may put other peo-

ple on the road at risk. All loose parts

should therefore be removed from the

FLYER before you start riding.

• A roof rack changes the total height of

your vehicle.

• Pay close attention to the maximal

load capacity if you transport your

bike on the roof of a vehicle.

The brake lever may not be used when

your bicycle is lying sideways, upside

down or if a wheel has been removed.

Otherwise air bubbles can enter the hy

draulic system which could cause the

brakes to fail. After transporting the bicy

cle, check if the pressure point of the

brakes seems softer than before. Then

apply the brakes slowly several times.

This allows the braking system to dis

charge any bubbles. If the pressure

point remains soft, please refrain from

riding. A FLYER specialist retailer must

discharge the air from the brake system.

You can avoid this problem by applying

the brake lever before transport and

then xing it in this position using a

strap. This prevents any air from enter

ing the hydraulic system. Please note

that the brake lever may not be pulled

when the wheel has been removed.

Place a spacer between the brake

blocks if you need to remove the wheel.

• Do not transport your e-bike upside

down. When securing the bike, en

sure that no damage is caused to the

fork or the frame.

• You may not attach your e-bike to the

roof rack or rear carrier by its crank

set. The e-bike must always be trans

ported standing on its wheels. Non-

compliance may result in damage to

the e-bike.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Flyer Mountain - Bosch 2019 Seite 205

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info