Bedienungsanleitung Flyer RS serie - Panasonic (Seite 146 von 275) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Norwegisch)

732994

146

Zoom out

Zoom in

Vorherige Seite

1/275

Nächste Seite

144

• Check whether both wheels are correctly and

rmly attached to the frame and fork, that both

the front and rear wheels rotate freely and that

the rim runs straight past the brakes without

snagging. The tyres must not touch the brakes.

Experts can see from the distance between the

frame or fork and the wheel whether the wheel

turns without snagging.

• Check that both brakes are operating fully.

• Do not set off again without having checked

that the chain is sitting securely on both the

front chain wheel and rear sprockets. It must

be engaged fully with the cogs. If you set off

and the chain jumps off a cog you may fall, at

the risk of very severe injury.

• Check whether the display of the FLYER e-bike

shows a fault message or a warning. Do not

drive your FLYER when a warning is displayed.

Immediately contact your FLYER specialist re

tailer.

• Check that the display and the battery are un

damaged. Do not ride your FLYER if there are

any noticeable changes (cracks, scratches,

etc.). Have all parts and functions rst checked

by your FLYER specialist retailer.

There is a risk that humidity or water

may penetrate the motor if the housing

of your battery is cracked. This may lead

to short circuits or electrical shocks. Im

mediately stop using the battery in this

case and contact your FLYER specialist

retailer. Do not charge the battery.

If you notice any changes to your bicycle, DO

NOT continue cycling. Do not retighten any loose

parts without rst checking them and always use

a torque wrench. Take the FLYER to your FLYER

specialist retailer, describe the fall to them and

have the bicycle checked out!

11. Adjusting the

bike to the rider

Installing pedals

Always have your pedals installed or changed

by your FLYER specialist retailer, and feel free to

ask for advice their correct handling. Pedals must

be installed with a suitable spanner. Please note

that the two pedals are screwed on in different

directions and must be fastened with high torque

(see Chapter 24.2). Apply assembly grease to

both threads.

Please take note that the right pedal is different

from the left. You can recognise which pedal be

longs on which side from the screws which turn in

opposite directions. Usually, an “R” is embossed

on the right pedal with an “L” on the left. Screw the

right pedal clockwise and the left pedal anti-clock

wise into the cranks.

The pedals must be fastened with a suit-

able spanner. Adhere to the correct fas-

tening torque when screwing on the ped-

als, see Chapter 24.2 “Fastening torques

for screw connections”. Ensure that the

pedals are tted straight. If they are tted

at an angle, there is a danger of break

ing and of having a fall!

For safety reasons, we strongly advice

not using pedals with clips or straps.

Direction

* see Chapter 24.2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Flyer RS serie - Panasonic Seite 146

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Flyer RS serie - Panasonic

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info