Bedienungsanleitung Flyer Urban - Bosch 2016 (Seite 151 von 249) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Norwegisch)

780045

151

Zoom out

Zoom in

Vorherige Seite

1/249

Nächste Seite

149

Formation of air bubbles

You can avoid this problem by apply-

ing the brake lever before transport

and then xing it in this position using a

strap. This prevents any air from enter-

ing the hydraulic system. Please note

that the brake lever may not be pulled

when the wheel has been removed.

Place a spacer between the brake pads

if you need to remove the wheel.

Ask for detailed instructions regarding the opera-

tion and special features of the e-bike braking

system from your FLYER specialist retailer, even

if you are an experienced cyclist. Practise in a

quiet, safe area with no trafc.

If you have any questions about assembling, set-

ting up, servicing or operating this part of your

bike, please contact a FLYER specialist retailer.

A trigger point should be clearly noticeable

after approximately a third of the way

when pulling the brake lever. Do not start

to ride if the brake lever can be pulled up

to the handlebars. In this case, the FLYER

is not safe for operation. It is then essen-

tial to visit your FLYER specialist retailer

and have the brake adjusted or repaired.

Hydraulic rim brakes

Due to the wear and tear put on the brake pads,

the brake levers will eventually need to be pushed

down harder to operate. When this happens, you

may have to adjust the rim brakes. As is the case

for most bike models, this can be done by adjust-

ing a screw or a setting wheel on the brake lever.

Ask your FLYER specialist retailer for details.

Brake blocks/pads and rims are wearing parts

due to their use. Have the state of wear inspected

at regular intervals by your FLYER specialist re-

tailer. Grooves in the brake blocks and embedded

points in the rims help you determine the level of

wear. If the grooves in the brake pads or the dots

on the rims aren’t visible, it means that they are

worn out and either the brake pads or the rims

must be replaced. Always change both brake

blocks at the same time.

New rim (with points

to indicate wear)

Worn rims

Brake discs and brake pads are particu-

larly subject to wear. Have these safety-

related components regularly checked

for wear and changed as required by

your FLYER specialist retailer.

If the brake system needs to be cleaned, contact

your FLYER specialist retailer. The component

manufacturer's instructions on how to clean the

brake system are provided in the respective brake

system manual.

Only allow your FLYER specialist retailer to

maintain the brake system and change individual

brake system components. Only original spare

parts may be used. Otherwise it is possible that

the functionality of your FLYER e-bike may be im-

pacted or damaged.

Have the brake pads regularly checked accord-

ing to manufacturer specications by your FLYER

specialist retailer.

It is essential to switch off the electrical

operating system and remove the bat-

tery before any form of maintenance

work is carried out.

New brake pads Worn out brake pads

Source: Shimano® techdocs

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Flyer Urban - Bosch 2016 Seite 151

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info