Bedienungsanleitung Focus SlimFocus (Seite 16 von 28) (Englisch)

810226

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Turn the appliance OFF and isolate the gas supply. Ensure the appliance

is fully cold before attempting to start servicing the appliance. No liability

can be accepted by Focus for injury caused by burning or scolding by a

hot appliance.

A suggested procedure for servicing is listed below.

A. Lay out dust sheet on flooring, mask off any special fireplace materials.

B. Open Outer Firebox Access Door.

C. Remove Inner Access Door.

D. Carefully remove the Ceramic components (including Embers)

or Gravels

E. Use a Vacuum cleaner to clean the top of the burners and grate

F. Remove Grate

G. Use the vacuum cleaner and a soft brush to clean the pilot assembly

and both Injectors. It may be easier to access the Injector by

removing the Throttle. Never modify or bend the Thermocouple.

H. Clean the Window Panel.

I. Turn on the gas supply and check for leaks, check the burners and

Pilot for good condition and operation

J. Replace Grate

K. Replace the Firebed arrangements

L. Replace the access doors.

M. Check the flue system and terminal, making sure that the terminal

vent is fully clear

N. Light the appliance and test setting pressures

O. Check the safe operation of the appliance.

CLEANING THE CERAMICS

Remove the ceramics as detailed in A - E above.

Gently clean the ceramics in the open air, using a soft brush and a vacuum

cleaner. Where necessary replace damaged components only with

genuine Focus specified parts. Seal any scrap ceramics in plastic bags

and dispose at proper refuse sites. When using a vacuum cleaner, it is

recommended that one with a HEPA filtering system is used.

Re-fit the Firebed arrangement, re-seal the appliance and check the safe

operation of the appliance.

SERVICING THE BURNER

A fault finding chart is included in the appendix for the Mertik control

system fitted to this appliance.

Access the Burner as detailed in A - F above.

The pilot is now clearly visible, the pilot, including the Thermocouple,

can be replaced/serviced by removing raising the pilot assembly from its

mounting. This is done by removing the two screws on the surface of the

pilot. The fittings on the under-side of the pilot can be un-done using a

10mm spanner where appropriate.

The Main Burner Injectors can be accessed from the underside of the

appliance. If the burner requires to be removed, this may be done by

removing the 4 M6 fixings inside the firebox (10mm Spanner), the burner

will lift out through the Firebox.

When replacing any parts use only original Focus specified parts.

SPARE PARTS

Item Slimfocus

Window Panel xxxxxxx

Ceramic Log Pack xxxxxxx

Ember Pack xxxxxxx

Gravel Pack xxxxxxx

Pilot Assembly Natural xxxxxxx

Pilot Assembly LPG xxxxxxx

Electrode xxxxxxx

Electrode Lead xxxxxxx

Thermocouple xxxxxxx

Injector Natural Front xxxxxxx

Injector Natural Rear N/A

Injector LPG Front xxxxxxx

Injector LPG Rear N/A

Complete Burner Assembly Natural xxxxxxx

Complete Burner Assembly LPG xxxxxxx

Burner Seal xxxxxxx

Grate Assembly Standard xxxxxxx

Grate Assembly Tear & Deform xxxxxxx

Gas Valve Assembly Natural xxxxxxx

Gas Valve Assembly LPG xxxxxxx

Latching Solenoid xxxxxxx

Receiver unit xxxxxxx

Handset xxxxxxx

Access Door Assembly xxxxxxx

Servicing

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Focus SlimFocus Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info