624374
82
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
82
SPECIFICATIONS
MIC INPUT RESPONSE
Gain range = 0 dB to 60 dB continuously
variable.
Input Impedance = 1K4 from 10 Hz to 200
kHz.
EIN = 128 dB measured at 60 dB of gain with
150 terminating impedance and 20 Hz/22 kHz
bandpass filter.
THD at minimum gain (0 dB) = 0.0004%
measured with +16 dBu input signal and with a
20 Hz/22 kHz bandpass filter.
THD at maximum gain (60 dB) = 0.003%
measured with a –36 dBu input signal and with a
20 Hz/22 kHz bandpass filter.
THD at maximum input level (26.5 dBu) =
0.005% measured with a 20 Hz/22 kHz bandpass
filter.
Frequency response at minimum gain (0 dB) =
flat at 10 Hz and –2 dB down at 200 kHz.
Frequency response at maximum gain (60 dB) =
–2 dB down at 10 Hz and 200 kHz.
CMRR at full gain (60 dB) = 80 dB.
LINE INPUT RESPONSE
Gain range = -10 dB to +10 dB continuously
variable.
Input Impedance = 10K from 10 Hz to 200
kHz.
Noise at main output with gain and fader set to
unity (0 dB) = -94 dBu measured with a 20
Hz/22 kHz bandpass filter.
Signal to noise ratio relative to max headroom (27
dBu) = 121 dB.
Signal to noise ratio relative to 0 dBfs (+22 dBu)
= 116 dB.
THD at unity gain (0 dB) = 0.0006% measured
with 0 dBfs (+22 dBu) input signal and with a 20
Hz/22 kHz bandpass filter.
Frequency response at unity gain (0 dB) = 0.25
dB down at 10 Hz and –3 dB down at 200 kHz.
INSTRUMENT INPUT RESPONSE
Gain range = 0 dB to 40dB continuously variable.
Input Impedance = > 1 Meg .
Noise at minimum gain (0 dB) = -90 dBu
measured with a 20 Hz/22 kHz bandpass filter.
Noise at maximum gain (40 dB) = -78 dBu
measured with a 20 Hz/22 kHz bandpass filter.
THD at minimum gain (0 dB) = 0.006%
measured with –10 dBu input signal and with a 20
Hz/22 kHz bandpass filter.
Frequency response at unity gain (0 dB) = 0.5 dB
down at 10 Hz and –1 dB down at 200 kHz.
Frequency response at maximum gain (40 dB) = 6
dB down at 10Hz and –1dB down at 200KHz.
INPUT METER
6 LED peak reading meter is calibrated relative to
0 dBfs where 0 dBfs = +22 dBu (the maximum
level which can be correctly converted by the
optional internal A/D converter before overload
occurs). The meter calibration points are as
follows: -
Meter panel
calibration value
Equivalent dBu value
O/L +22.4 dBu (the point at which
the converter will overload)
0 dBfs +22 dBu (the maximum level
into the converter)
-3 dBfs +19 dBu
-6 dBfs +16 dBu
-10 dBfs +12 dBu
-20 dBfs +2 dBu (the average level to
allow 20 dB of headroom for Eq
and dynamics processing).
HIGH PASS FILTER
Roll off = 18 dB per octave 3 pole filter.
Frequency range = continuously variable from 30
Hz to 400 Hz measured at the 3 dB down point.
OPTICAL EXPANDER
Threshold hold range = -20 dBfs (0 dBu) to –60
dBfs (-40 dBu).
Expander ratio = 2:1
Attack time = 750 µs.
Release time = 0.25 s to 4 s.
Noise with maximum expansion = -96 dBu
measured with a 20 Hz/22 kHz bandpass filter.
Signal to noise ratio relative to max headroom (27
dBu) = 123 dB.
Signal to noise ratio relative to 0 dBfs (+22 dBu)
= 118dB.
6 LED meter shows downward expansion
calibrated in dB increments.
Threshold range:
82

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Focusrite VoiceMaster Pro wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info