Bedienungsanleitung FoodSaver IFS005X (Seite 10 von 108) (Alle Sprachen)

783496

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

www.foodsavereurope.com 10

Troubleshooting

Problem Solution

The Instant Seal light is flashing

when trying to seal. Under very heavy usage, this will happen to prevent overheating. If this happens wait 20 minutes to

allow appliance to cool off. During use, always wait at least 20 seconds before you begin vacuum

packaging another item.

Pump operates for more than 2

minutes without air being removed. Make sure the open end of the bag is inserted into the drip tray within the lower gasket area.

Check to make sure both gaskets are fitted properly and not damaged.

Check to make sure that at least one end of the bag is sealed.

Open the unit and check to make sure that there are no foreign objects, dirt or debris on the upper or

lower gaskets.

Make sure there is enough room at the top of the bag (75 mm) so it will fit into the drip tray with lid

closed and latched.

Make sure the accessory hose is not attached.

Make sure the lid is fully closed with the latch in the closed position

Bag is not sealing properly. There is moisture or grease in the bag at the sealing point. Wipe away any excess moisture with a

clean, dry paper towel.

There is too much liquid in the bag. Freeze the bag contents before vacuuming.

There is a crease on the seal line. Gently stretch the bag flat while inserting the bag into the drip tray

and continue to hold bag until vacuum pump starts. If this has already been done and the bag still

does not seal, create a second seal above the first one.

Nothing happens when the lid is

closed and the Vacuum and Seal

button or Instant Seal button is

pressed.

Make sure the lid is fully closed with the latch in the closed position

The Power light has gone out when

the lid is closed and the latch is in

the closed position.

If the appliance is left untouched for 12 minutes, it will enter Standby mode and all indicator lights will

remain off. Press the appropriate function button to return to the required mode (e.g. Vacuum and

Seal).

Installation of a plug

If the plug is not suitable for the socket outlets in your home, it can be

removed and replaced by a plug of the correct type. If you remove the

plug it must not be connected to a 13 amp socket and the plug must

be disposed of immediately.

NOTE: If the terminals in the plug are not marked or if you are unsure

or in doubt about the installation of the plug please contact a qualified

electrician.

If a 13A 3-pin plug is fitted, it must be an ASTA approved plug,

conforming to BS1363 standard. Replacement fuses must be BSI or

ASTA BS1362 approved.

The wires in the mains lead are coloured as such:

• BROWN - LIVE

• BLUE - NEUTRAL

Please note that the colour of these mains wires may not correspond

with the colour markings that identify the terminals in your plug.

The BROWN coloured wire must be connected to the terminal, which

is marked with the letter “L” or is coloured RED.

The BLUE coloured wire must be connected to the terminal, which is

marked with the letter “N” or is coloured BLACK.

DO NOT CONNECT either of these wires to the earth terminal in the

plug. The earth terminal plug is marked with the letter “E”, or with the

earth symbol , or coloured GREEN, or GREEN and YELLOW.

Do Not Connect

Mains Wires Here

Blue

(Neutral)

Brown

(Live)

Fuse

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

FoodSaver IFS005X Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info