768947
13
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
CHIC 13
INSTALL THE SEAT (g.19, g.20, g.21, g.22, g.23)
Align the seat with the adaptors and press until “click” sound.
Lift up the buttons of the adaptors with one nger at each side and lift up the seat to remove the
seat.
REVERSIBLE SEAT(g.24, g.25, g.26)
Lift buttons “A” on both sides and remove the seat by lifting it.
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph “INSTALL THE SEAT” for correct
assembly.
TO REGULATE THE BACKREST (g.27)
Lift the regulating lever located behind the backrest and recline the backrest to the required
position. Release the lever and make sure the backrest is secured in position.
SAFETY HARNESS (g.28)
Apply the brake before placing your baby in the pushchair.
Release the buckle: press button “A” and remove the components
Fasten the buckle: by inserting part a in part b, a click will indicate that it has been
fastened correctly.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance with
the standard BS 6684.
ADJUSTING THE CANOPY (g.29, g.30)
Extend the hood according to requirements to protect baby from the sun.
Note: babies’ skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
Remove the rear part of the hood to use it as a parasol.
FOLDING THE PUSHCHAIR (g.31, g.32, g.33)
Before folding the pushchair, make sure that:
The seat is forward facing
The backrest is adjusted in the upright position
The canopy is folded
Push the button “A”, on the lower side of the right lever and keep pressed while sliding the levers,
left and right, downwards. Fold the stroller. Ensure the locking device “B” is correctly engaged.
Note: It is NOT possible to close the pushchair with the travel system accessories, the infant car seat
and carrycot, tted on the chassis.
FITTING THE FOOTMUFF (g.35)
Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair using the press fasteners.
FITTING THE PUSHCHAIR RAINCOVER (g.35)
Fit the raincover over the hood.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
GB ASSEMBLY
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Foppapedretti Chic wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info