4. Remove the wiper blade.
5. Install in the reverse order.
Note: Make sure that the wiper blade locks
into place.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
Note: To avoid damage to the internal
structure of the wiper blade, only move it
using the center connection of the wiper
arm.
ADJUSTING THE HEADLAMPS
You can adjust the headlamp beams for
when you drive on the right-hand side or
left-hand side of the road.
1. Remove the headlamps. See
Removing a Headlamp (page 152).
2. Remove the covers. See Changing a
Bulb (page 153).
3. Slide the control on each headlamp to
adjust the headlamp beam.
Note: When you return to driving on the
other side of the road, remember to change
the headlamp beams to the original setting.
REMOVING A HEADLAMP
1. Open the hood. See Opening and
Closing the Hood (page 143).
2. Remove the screws and push pins.
3. Lift the outer side of the headlamp to
disengage it from the lower fixing point.
4. Pull the headlamp as far as possible
toward the center of your vehicle and
remove.
5. Disconnect the two electrical
connectors.
152
B-MAX (CB2) Vehicles Built From: 10-03-2014 Vehicles Built Up To: 03-05-2015, CG3573en enGBR, Edition date: 02/2014, Third Printing
Maintenance
