Bedienungsanleitung Ford Galaxy - feb 2011 - okt 2011 (Seite 9 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

531193

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

ENGLISH

X Remove the container (9) from the appliance by pressing

the two release buttons (31) and lifting the container out of

the appliance.

X Press the lower door latch (32) to release the dirt.

X Empty the container as necessary.

X Clean the filter as described below.

X Close the lower door and make sure that it clicks into place.

X Re-fit the container (9) into the appliance, make sure that

the release buttons (31) click into place.

X Press the filter cleaning switch (3) and the filter cleaning

cycle will run for 10 seconds, after which it will

automatically switch off. This will ensure that the next time

the appliance is used, the performance will be at it's

optimum.

Cleaning

Warning! Before cleaning and maintenance, switch the

appliance off and unplug it.

X From time to time wipe the appliance with a damp cloth. Do

not use any abrasive or solvent-based cleaner. Do not

immerse the appliance in water.

Cleaning the container filters (fig. H - K)

The container filters prevent dust and dirt from entering the

motor housing. The filters are re-usable and should be

cleaned periodically.

X Remove the container from the appliance (fig. H).

X Press the lower door latch (32) to release the lower door

(fig. I).

X Remove the pre-filter (33) from the container (9) (fig. J) by

rotating anti clockwise.

X Pull the filter (34) off the filter holder (fig. K).

Warning! Do not brush or use compressed air to clean the filter.

X Depending on its condition, rinse the outside of the filter

with water. Allow the filter to dry for 24 hours before

reinserting it.

Warning! Do not wash the inside of the filter.

X Replace the filter.

X Re-fit the pre-filter.

X Close the lower door.

X Re-insert the container into the appliance.

Cleaning the motor filter (fig. H & L)

The motor filter (35) prevents particles and larger objects

from entering the motor housing when the container is

removed.

The filter (35) is re-usable and should be cleaned regularly.

X Remove the container from the appliance (fig. H).

X Take the filter (35) out (fig. L).

X Brush any loose dust off the filter.

X Replace the filter (35).

X Re-insert the container into the appliance.

Replacing the filters

If the container filter (34) is damaged or fails to operate

properly, it must be replaced. Replacement filters are

available from your Black & Decker dealer (cat. no. VLF50).

Replacing the container filter

X Proceed as described above to replace the filter (34).

Replacing the outlet filter (fig. M & N)

The appliance is fitted with a lifetime filter but if it is

required to be replaced, replace it as follows:

X Remove the two screws (36)

X Remove the cover (37) by using a tool to lift the cover up.

X Remove the old filter (38) by pulling it out.

X Insert the new filter as shown.

X Refit the cover with the two screws (36).

Mains plug replacement (U.K. & Ireland only)

If a new mains plug needs to be fitted:

X Safely dispose of the old plug.

X Connect the brown lead to the live terminal in the new plug.

X Connect the blue lead to the neutral terminal.

Warning! No connection is to be made to the earth terminal.

Follow the fitting instructions supplied with good quality plugs.

Recommended fuse: 5 A.

Protecting the environment

Should you find one day that your tool needs

replacement, or if it is of no further use to you,

think of the protection of the environment. Black

& Decker repair agents will accept old Black &

Decker tools and ensure that they are disposed of

in an environmentally safe way.

Separate collection of used products and

packaging allows materials to be recycled and

used again. Re-use of recycled materials helps

prevent environmental pollution and reduces the

demand for raw materials.

Local regulations may provide for separate collection of

electrical products from the household, at municipal waste

sites or by the retailer when you purchase a new product.

Black & Decker provides a facility for the collection and

recycling of Black & Decker products once they have reached

the end of their working life. To take advantage of this

service please return your product to any authorised repair

agent who will collect them on our behalf.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ford Galaxy - feb 2011 - okt 2011 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ford Galaxy - feb 2011 - okt 2011

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info