Bedienungsanleitung Freerider FR510DXXs (Seite 10 von 48) (Englisch)

664131

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

gentle operation, and clockwise towards maximum to

increase your speed. When attempting to climb

obstacles, you will need to set the dial to a high setting.

Remember the higher position you set your speed dial to,

the faster your Scooter will travel. Caution: The speed

adjustment dial(1)works in conjunction with the Hi/Low

speed switch (2),if both are set to their lowest settings

there may not be sufficient power delivered to the motor

to drive your Scooter, in this case turn the speed dial up

to a higher setting.

Located on the left side of your

console this switch controls the maximum high (Hi) and

low (Lo) speed range for your Scooter.

When riding on the pavement or in shopping areas the low

4mphspeed range must be engaged,

When

the low speed range is chosen a 'red' warning light (see

fig 11 No.7) will illuminate. The Hi/Lo speed range switch

can be operated while the Scooter is in motion.

Please note the Hi/Lo speed swith works in conjunction

with the speed adjustment dial (see fig 11 No.1) and the

forward/reverse speed lever; the speed dial must be set to

it's highest setting for maximum speed in both Hi and Lo

speed settings.

This rocker type switch controls

the function of the front and rear lights. Simply push down

on the left side for 'on' and the right side for 'off'.

Located at the bottom

right of your console, the direction indicator lights for

right and left manoeuvers are controlled by this switch.

When making a turning manoeuvre on the road the

appropriate switch direction should be made. Simply,

when turning right 'flick' the switch to the right, you will

note a warning 'bleeper' is audible and the appropriate

direction warning light (see fig 11 No.6) Will flash. To

cancel the direction indicator return the switch to the

centre position. The left direction indicators are activated

by 'flicking' the switch to the left. Please note

the direction indicators are not self-cancelling.Warning:

Please be aware to test the function of your direction

lights before each journey. Failure to observe this warning

could put you and other road users into a dangerous

situation. If in the event a direction indicator bulb fails,

you will note the direction warning light (see fig 11 No.6)

on your console flashing quicker than normal, in this

situation the appropriate bulb should be substituted.

Located at the top

of your console. This is a 10 bar segmented colour

illuminated display which indicates when your Scooter is

switched on, it also displays the status of the batteries, the

speed controller and the Scooter's electrical system.

' When your Scooter is switched on, after

half a second, the coloured bars will illuminate to show the

level of charge in your batteries. If the batter gauge

displays red, yellow and green your batteries are fully

NOTE:

2. Hi/Lo speed Switch:

Freerider

3. Front/Rear Light Switch:

4. Direction Indicator Light Swithc:

5. Batter Gauge/Status Indicator Light:

Battery Gauge':

this is a lega

requirement and must be adhered to at all times.

Caution:

NOTE:

Hi/Lo

speed

Switch:

Freerider

Front/Rear

Light

Switch:

Direction

Indicator

Light

Swithc:

Batter

Gauge/Status

Indicator

Light:

Battery

Gauge':

Caution:

charged and you are ready to drive. As the power is used

up in your batteries the bar indication will move towards

the red sector indicating the state of charge at thaat precise

time.

If the batter gauge displays red and yellow, then your

batteries have lost charge and they should be recharged as

soon as you can, but you will still have power to spare.

When the battery gauge falls into the red sector, either

steady or flashing slowly, then you should charge your

batteries without delay.

It is not recommended to drive your Scooter regularly with

the batter charge indication in the yellow to red sector, as

this will shorten batter life. It is wise to re-charge your

batteries after each journey especially as it enters the

yellow to red sectors of your battery gauge(see Batteries

and Battery Charging section of this manual ) Note:When

driving up steep slopes or similar obstacles your

Scooter's motor will be working hard, the battery

gauge may move towards the red sector, it will recover

towards the green sector once the load on your motor is

reduced, this does not indicate low batteries.

' When you turn your

Scooter on, after half a second the battery

bar gauge will illuminate at a constant rate indicating the

state of charge level in your batteries. The battery bar

gauge is connected to a very sophisticated diagnostic

system which can identify faults should they occur on the

main speed control system or some other part of your

Scooter's electronic drive system .If in the unlikely event a

fault should occur with your Scooter you can

find out what has happened by counting the number of

bars that are flashing on the battery gauge. For instance if

your batteries run low on power, the status indication will

flash slowly one bar, indicating that the batteries need

recharging or that there is a poor connection to the

batteries. The Battery Status Bar Gauge detects 8 similar

fault diagnostic signals, reference to these diagnostic codes

is found under 'Basic fault finding' on page31.

This green light will illuminate

when the direction indicator switch is activated to the right

for a right turn and to the left for a left turn. The light will

also flash at a higher rate than normal to indicate a bulb

failure in one of the front or rear direction lights.

This red light will

illuminate when the Hi/Lo speed switch is engaged in the

slow speed position, see also point No.2 above -Hi/Lo

speed switch.

Located on the right side of your

control console. Insert the key and turn clockwise .This

controls the power to your speed control system. You will note

that after half a second the battery condition gauge will

illuminate with a solid light. Your Scooter is now ready to

drive. To switch off your Scooter turn the key anti-clockwise.

Remove the key when your vehicle is left unattended.

Do Not switch to 'off' when your Scooter

Status Warning Indicator':

Freerider

6. Direction Warning Light:

7. 4m.p.h. Lo Speed Warning Light :

8. On-Off Power Switch:

Caution:

Status Warning Indicator':

Freerider

Direction Warning Light:

4m.p.h. Lo Speed Warning Light :

On-Off Power Switch:

Caution:

Freerider FR510DXXs Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info