3
Insert a flat bladed screwdriver into
the slot A at the base of the push.
Carefully lever the cover and base
apart (Fig. 1).
Open the bell push
A
Fig. 1
Insert the CR2032 coin cell. Ensure the face
marked ‘+’ is uppermost (Fig. 2).
To fit the push battery
Fig. 2
CR2023
+
To remove the chime battery cover, press at
point B and slide the cover back 5mm, then lift
off. Insert 3 x LR6 ‘AA’ alkaline batteries (not
supplied). Observe polarity as marked inside
the battery compartment.
Fit the chime batteries
Fig. 3
B
The volume control is behind the sliding window on
the front of the chime. Initially, set the control to
mid-point. After you have tested your system,
adjust to the desired volume.
Volume
control
Fig. 4
Volume control
