560835
16
Zoom out
Zoom in
Vorherige Seite
1/232
Nächste Seite
16
Letters
Digits
Letters
Digits
. @ / : - _ → ^
1
PQRS/pqrs
7
ABC/abc
2
TUV/tuv
8
DEF/def
3
WXYZ/wxyz
9
GHI/ghi
4
# $ % * + < >
<> = [ ] ←→ `
0
JKL/jkl
5
! ? - , ' ; ( ) & " |
*
MNO/mno
6
#
6.2.1.4 Learning the remote control (LEARNING ID)
The control panel can learn up to 8 remote controls.
1. Press the button on the remote control. The control panel emits two short beeps. The display shows “NEW DEVICE”.
Note: If the remote control has already been linked, the control panel will emit one long beep.
2. Press the button on the remote control within 15 seconds to confirm the ID code. The control panel emits three
short beeps. The display shows “DEVICE CONFIRMED” > “SAVING NEW DEVICE”.
Note: If the confirmation signal is not received within 15 seconds, the control panel will emit one long beep and exit learn
mode.
Message
Meaning
LEARNING OK
The ID code was learned by the control panel successfully.
TIME OUT
If you do not press the buttons on the remote keypad within 60 seconds,
a time-out will occur.
ID DUPLICATE
The same ID code was learned by the control panel beforehand.
6.2.1.5 Personal attack button (PANIC)
If you press the personal attack button ( ) on the remote control, the control panel will generate an alarm.
6.2.1.6 Status (STATUS)
The remote control will control the control panel if the remote control is lost unexpectedly.
6.2.1.7 Deleting the remote control (DEL DATA)
You can delete the settings of the remote control from the control panel.
6.2.2 System setup (SYSTEM SETUP)
PROGRAM MODE
2. SYSTEM SETUP
2-1 ALARM TIME
10 SEC / 30 SEC / 1 MINUTE
/ 3 MINUTES / 5 MINUTES /
10 MINUTES
2-2 INT. SIREN
SELECT ON>* / OFF>#
2-3 EXT. SIREN
:3-1 WIREFREE SIREN
:1-1 LINK PANEL TO SIREN
SENDING ID CODE. WAIT
15S.
:1-2 SIREN WORKING
SELECT ON>* / OFF>#
:3-2 NIGHT ALARM
SELECT ON>* / OFF>#
2-4 ERROR BEEP
10 SEC / 30 SEC / 1 MINUTE
/ 2 MINUTES / 4 MINUTES /
OFF
2-5 RF JAMMING
DETECTION
SELECT ON>* / OFF>#
2-6 ALARM RELAY
PULSE 2 SEC / PULSE 30 SEC
/ PULSE 1 MINUTE / PULSE
3 MINUTES / PULSE 5
MINUTES / ON UNTIL
DISARM
2-7 ZONE LOCK
SELECT ON>* / OFF>#
2-8 PART ARM-I SETUP
:9-1 EXIT DELAY
SELECT ON>* / OFF>#
:9-2 ENTRY DELAY BEEP
SELECT ON>* / OFF>#
:9-3 EXIT DELAY BEEP
SELECT ON>* / OFF>#
2-9 PART ARM-II SETUP
:10-1 EXIT DELAY
SELECT ON>* / OFF>#
:10-2 ENTRY DELAY BEEP
SELECT ON>* / OFF>#
:10-3 EXIT DELAY BEEP
SELECT ON>* / OFF>#
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Friedland FGGK Series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info