Bedienungsanleitung Friedland HISK1 GlobalGuard Alarm System (Seite 14 von 78) (Englisch)

535711

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

EXTERNAL SOLAR SIREN

The Siren is encapsulated within a tough

polycarbonate housing that also provides full

protection against adverse weather conditions.

An LED indicator unit is built into the Siren to act

as a visible deterrent and indication that the

system is active. The LEDs will slowly and

alternately flash whether the system is Armed or

Disarmed. When an alarm occurs the LEDs will

flash rapidly together.

An integral tamper switch provides additional

security protection to the Siren and will

immediately trigger an alarm should any

unauthorized attempt be made to interfere with

and remove the Siren cover.

The Siren is powered by a rechargeable nickel-

metal hydride (NIMH) battery. A solar panel

mounted on the top of the housing charges the

battery during daylight hours. During darkness,

only a small amount of energy is required to

operate the Siren unit.

POSITIONING THE SOLAR SIREN

The recommended mounting height for the Siren

is at first floor window height of your property on

the external wall so that it can be easily seen

and heard. The Siren should be mounted on a

sound flat surface so that the rear tamper switch

is not activated when mounted.

Ensure that the tamper switch does not fall

into the recess between brick courses as this

could prevent the switch from closing and

give a permanent tamper signal.

In order to provide the maximum amount of

daylight to the solar panel, the Siren should

ideally be mounted on a south facing wall.

However, an easterly or westerly position will

suffice. Mounting the device on a north facing

wall should be avoided as this could mean that

during the short dark days of winter months the

solar panel may not receive sufficient daylight in

order to maintain the battery charge at

acceptable levels.

Shadows cast by neighboring walls, trees and

roof overhangs should also be avoided. If the

Siren is to be mounted below the eaves, it

should be positioned a distance of at least twice

the width of the eaves overhang below the

eaves. Remember that in winter the sun is

lower in the sky and you should avoid winter

shadows where possible.

The Solar Siren contains a sophisticated radio

receiver. However, reception of radio signals

can be affected by the presence of metallic

objects within the vicinity of the Siren. It is

therefore important to mount the Siren a

minimum distance of 1 metre away from any

external or internal metalwork, (i.e. drainpipes,

gutters, radiators, mirrors etc). Be especially

aware of radiators mounted on the inside wall

behind possible locations for the Siren.

Ensure that the position selected for the Siren is

within effective range of the Control Panel.

CONFIGURING THE SOLAR

SIREN

The Siren has already been pre-linked to the

Control Panel from the factory. It has also

been preconfigured to operate with your

system.

However should you wish to change the DIP

switch settings in the battery compartment,

please read as follows:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Friedland HISK1 GlobalGuard Alarm System Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info