Bedienungsanleitung Frigidaire CPA123DU1 (Seite 12 von 13) (Englisch)

603131

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

OCCURRENCE SOLUTION

Wall plug disconnected. Push plug firmly into wall outlet.

Plug Current Device Tripped. Press the RESET button.

House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.

Control is OFF. Turn Control ON and set to desired setting.

P1 appears in the display window. Drain water as described in Drainage Section.

Room Temperature lower than the set temperature (Cool Mode). Reset the temperature.

Room Temperature higher than the set temperature (Heat Mode). Reset the temperature.

Shut off in Heat mode. When the air outlet overheats, the automatic heat protection engages. Remove

any blockages and let appliance cool down. If the heating function can not be restarted after fully

cooling down, the thermal fuse may open the heater circuit, then call for service.

Air conditioner will not operate.

Air conditioner cooling, but room

is too warm - NO ice forming on

cooling coil behind decorative

front.

Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.

Temperature is set too high. Set temperature to a lower setting.

Air directional louvers positioned improperly. Position louvers for better air distribution.

Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in

front of unit.

Doors, windows, registers, etc. open - cool air escapes. Close doors, windows, registers, etc.

Unit recently turned on in hot room. Allow additional time to remove “stored heat” from walls, ceiling,

floor and furniture.

Air conditioner turns on and off

rapidly.

Dirty air filter - air restricted. Clean air filter.

Outside temperature extremely hot. Set FAN speed to a faster setting to bring air through cooling coils

more frequently.

Before You Call

Air conditioner cooling, but room

is too warm - ice forming

on cooling coil behind decorative

front

Outdoor temperature below 16 °C (60 °F). To defrost the coil, set FAN ONLY mode.

Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set to FAN ONLY

mode.

Temperature is set too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then,

set temperature to a higher setting.

Ducts not connected or blocked. See HOSES INSTALLATION Section.

Room temperature below 16 °C (60 °F). Cooling may not occur until room temperature rises above

16 °C (60 °F).

Air from unit does not feel cold

enough.

Compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to

restart when set in the COOL mode.

Reset to a lower temperature.

Noise when unit is cooling.

Air movement sound. This is normal. If too loud, set to lower FAN setting.

Vibration from uneven floor. Move or support appliance correctly on even surface.

Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not

the result of defective workmanship or materials in this appliance.

If These Solutions Fail, Call 1-800-265-8352 For Frigidaire Service.

Room too cold.

Set temperature too low. lncrease set temperature.

Room too hot.

Set temperature too high. Lower setting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Frigidaire CPA123DU1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info