Installation
Placing
When the freezer is in operation, all four sides become hot. The freezer must therefore
be installed so that 5 cm of free space is left on all sides for the air to circulate freely and
conduct the heat away.
Place the freezer so that it is not heated by direct sunlight or heaters. Low ambient
temperatures and good room ventilation reduce energy consumption.
Operation
G-models
Thermostat, fast freeze switch and control lamps are placed in control panel at bottom right
front of freezer.
Thermostat
The temperature in the freezer is controlled by the thermostat. The thermostat button is
operated with a coin or similar.
Pos. 0: power to compressor is disconnected
Pos. 1: warmest thermostat setting
Pos. max.: coldest thermostat setting
Fast freeze switch
When the fast freeze switch is turned on and the yellow lamp lights, the compressor runs
continuously, and the temperature will stabilise at approx. -30°C.
When the fast freeze switch is turned off the thermostat assumes control of the tempe-
rature. The fast freeze switch is used for freezing fresh foods.
Red lamp (not mounted in model G)
The red lamp lights when the temperature in the freezer is more than 3°C above the
temperature for which the thermostat is set.
Green lamp
Remains on as long as there is power to the freezer.
T-models
The thermostat control is in the cover plate of the compressor compartment.
Thermostat
The temperature in the freezer is controlled by the thermostat. The thermostat button is
operated with a coin or similar.
Pos. 0: the power to compressor is disconnected
Pos. 1: warmest thermostat setting
Pos. max.: coldest thermostat setting
The freezing button and control lamps are placed in the handle on the lid
Fast freeze switch
When the fast freeze switch is turned on and the yellow lamp lights, the compressor runs
continuously, and the temperature is stabilised at approx. -30°C.
❆
7
DIRECTIONS
