Bedienungsanleitung Fujifilm Finepix 40I (Seite 7 von 58) (Englisch)

101074

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

●

Do not apply excessive force to the battery cover.

●

Always switch the camera off when replacing the

batteries. If the camera is left switched on, the

camera settings may revert to the factory default

settings.

●

If the AC power adapter has been connected or the

batteries have been installed for about half a day or

longer, the camera settings will be retained for about

half a day after the AC power adapter has been

disconnected and the batteries have been removed.

Check the date setting after you replace the batteries.

Plug the charger into a power outlet to begin charging.

Battery charging will be completed in about 13 hours,

but the power lamp remains lit. Unplug the battery

charger from the power outlet when it is not in use.

Slide the battery cover out to open it.

2 3

SELECTING THE POWER SUPPLY

Load the rechargeable batteries into the battery

charger as indicated on the label.

●

Ni-MH batteries are not fully charged at shipment

and must be charged before being used. Newly

purchased batteries or batteries that have been left

unused for an extended period may not be fully

charged. (This is indicated by the immediate display

of the battery low warning or a low number of

available shots.) This is a normal characteristic of the

batteries and does not indicate a fault. Repeatedly

charging and using the batteries 3 or 4 times will

restore them to a normal condition.

●

If the terminals of nickel-metal hydride batteries are

soiled, it may not be possible to charge them. To

avoid possible problems, clean the battery terminals

and charger terminals with a clean, dry cloth.

(Especially the first time you charge the batteries,

you should clean the battery terminals and charger

terminals and then insert the batteries into the

charger and remove them several times before you

start charging.)

●

Fully discharged Ni-MH batteries take approximately

13 hours (1,600 mAh) to recharge. KR-3UF Ni-Cd

batteries take approximately 8 hours to recharge.

Shorter charging times can be achieved using the

Ni-MH/Battery Charger BCH-NH (➡P.93).

●

If you recharge Ni-MH or Ni-Cd batteries before they

are fully depleted, this results in the “memory effect”

✽

which causes the battery low warning to appear sooner.

To restore the batteries to their normal condition, use up

all the charge in the batteries before recharging them.

✽ Memory effect: A phenomenon whereby the battery properties

are such that its capacity is lower than the

nominal amount.

●

Do not use old and new batteries together.

✽ The Shapes of the Battry charger, the plug and socket outlet

depend on the country.

■ Using Batteries

The FinePix40i takes 2 nickel-metal hydride

(Ni-MH) or Ni-Cd batteries. The two batteries

used should both be of the same type.

Lithium or manganese batteries should not be used at all as

they emit heat and can damage the camera.

●

AA-size Ni-MH batteries

Fujifilm HR-3UF: 2 (supplied with the camera or sold separately)

●

AA-size Ni-Cd batteries

Fujifilm KR-3UF: 4 (sold separately)

Attempting to charge batteries other than those specified

for use with the charger (such as manganese, alkaline or

lithium batteries) can cause the batteries to burst or leak.

This could result in a fire or injury and consequent

damage to the surroundings.

✽See P.108 for information on the number of shots that can

be taken using batteries.

◆Batteries that Can Be Charged◆

●

Alkaline batteries should only be used in an emergency. Note

the following when using alkaline batteries:

•

The battery terminals should be wiped clean with a clean, dry cloth.

•

The number of available shots and the audio playback times are

limited. The number of available shots and the audio playback

times vary depending on the battery brand and the ambient

temperature. At temperatures of +5°C (+40°F) and below, it may

not be possible to take pictures or play back music. The lens

cover may also fail to open or close fully.

•

Because you are using the FinePix40i with the LCD monitor

switched off, the power cuts out without a remaining battery low

warning being displayed (if the FinePix40i is used with the LCD

monitor switched off at temperatures of +20°C (+68°F) and above).

Number of available shots: About 30

Available audio playback time: About 100 minutes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fujifilm Finepix 40I Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info