Bedienungsanleitung Fujifilm Finepix F 410 (Seite 10 von 69) (Englisch)

101501

Zoom out

Zoom in

Vorherige Seite

1/69

Nächste Seite

◆

Checking the remaining battery charge

◆

●

The above estimates are for the still photography modes. In Playback mode, the transition from “X” to “C” may

take less time.

●

When the battery runs flat, the “C” is displayed and the camera automatically stops operating. When this occurs, the

camera may continue operating if you switch it back on even if you haven’t loaded a new or fully charged battery.

However, this may cause malfunctions that could lead to camera damage, such as the camera shutting down without

retracting the lens. Always load a new or fully charged battery.

●

Due to the nature of the battery, the battery low warning may appear early when the camera is used in cold locations.

This is normal and does not indicate a fault. We recommend that you warm the battery in your pocket or a similar

location before use.

SETTING THE DATE AND TIME

Changing the date and time To change the date display format

1 Press the “MENU/OK” button.

2 Press “d” or “c” to select “g” OPTION and

then press “a” or “b” to select “SET

–

UP”.

3 Press the “MENU/OK” button.

4 Press “a” or “b” to select “DATE/TIME”.

5 Press “c”.

See P.16 for information on setting the date and

time.

0103 020405

01 02

1 Press “d” or “c” to select the date format.

2 Press “a” or “b” to set the format. Refer to

the table below for details of the settings.

Setting Explanation

YYYY.MM.DD Displays the date in the “year.month. day” format.

MM/DD/YYYY Displays the date in the “month/day/ year” format.

DD.MM.YYYY Displays the date in the “day.month. year” format.

◆

Power Save Function

◆

If the camera is not used in any way for approx. 30 seconds when the camera functions are enabled, this

function temporarily switches features such as the LCD monitor off to reduce power consumption

(

➡P.84

)

. If the camera is then left unused for a further period

(

2 minutes or 5 minutes

)

, the Power Save

function automatically switches the camera off. To switch the camera back on, slide the Power switch to

the side to turn the camera off briefly and then turn it back on.

1 There is ample remaining battery charge.

(

Displayed for only 3 seconds when the camera is switched on or

the mode is changed.

)

2 The battery is approximately half charged.

(

Displayed for only 3 seconds when the camera is switched on or

the mode is changed.

)

3 Battery charge low. Replace or recharge the battery as it will run

out shortly.

4 The battery is exhausted. The display will shortly go blank and the

camera will stop working. Replace or recharge the battery.

Blinking red

Lit white

Lit red

Lit white

Switch the camera on and check that no battery level warning

(

Z, X or C

)

is displayed on the LCD

monitor. If the “

º” is displayed, the battery is fully charged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fujifilm Finepix F 410 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info