External flash settings (for flashes
with automatic flash control)
For external flash, refer to the user’s manual for the
flash and specify the settings as described below.
h Select External flash mode (TTL mode cannot be
used).
h Match the settings to the camera aperture setting.
Set the flash for the aperture setting measured by
the camera.
h Match the sensitivity setting (➡ P.33) to the
setting on the camera.
Select “ON” in this setting when using an external
flash unit. Synchronized shutter speeds up to
1/1000 sec. can be used.
●
!
The image may appear dark when the shutter speed is set to
speeds higher than 1/1000 sec.
●
!
Set the white balance (➡P.59) to AUTO or Custom white
balance (➡P.66).
1Close the built-in flash.
2Attach the synchronization cord from the external
flash to the Sync terminal on the camera by
pushing the cord into the terminal securely.
●
!
Built-in and external flash units cannot be used at the same
time.
2
01
02
3
The mode can be set to “N”, “M”, “<” (➡P.41, 42,
43) or “>” (➡P.44), but the use of “<” or “>” is
better.
●
!
Flash photography cannot be used when continuous shooting
(➡P.50) or auto bracketing (➡P.51) is selected.
Using a Sync terminal
