Bedienungsanleitung Funai LCD-C2717 (Seite 3 von 16) (Englisch)

503744

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

3 EN

PRECAUTIONS

POWER SUPPLY

The main power supply is engaged when the main plug is

plugged in a 220-240 V, 50 Hz AC outlet. To operate the unit,

press

STANDBY-ON to turn on the unit.

WARNING: LIVE PARTS INSIDE.

DO NOT REMOVE ANY SCREWS.

CAUTION

1) Do not attempt to open the cabinet. There are no parts

you can service inside. Refer all servicing to qualified

service personnel.

2) Slots and openings in the cabinet and the sides or bottom

are provided for ventilation. To ensure reliable operation

and to protect the unit from overheating, these openings

must not be blocked or covered.

Avoid installation in enclosed spaces such as bookcases

unless proper ventilation is provided.

3) Keep the unit away from radiators and other heat sources.

4) Do not push objects of any kind into the unit through the

cabinet slots or openings as they could touch electrically

live parts or short circuit parts resulting in a fire or electric

shock.

5) To prevent fire or shock hazard, do not expose this

apparatus to dripping or splashing, no objects filled with

liquids, such as vases, should be placed on the apparatus.

6) Use this unit in a horizontal (flat) subsoil only.

7) Do not place any combustible objects on the device

(candles, etc.).

8) The LCD panel used in this product is made of glass.

Therefore, it can break when the product is dropped or

applied with impact. Be careful not to be injured by

broken glass pieces in case the LCD panel breaks.

The LCD panel is a very high technology product with

921,600 thin film transistors, giving you fine picture

details. Occasionally, a few non-active pixels may appear

on the screen as a fixed point of blue, green or red. Please

note that this does not affect the performance of your

product.

9) Disconnect the mains plug to shut off when find troubles

or not in use.

10)The mains plug shall remain readily operable.

11)Read both manual instructions to ensure correct and safe

installation and interconnection of the unit in multimedia

systems.

12)Keep the distances 20 cm around apparatus of ventilation

openings.

Connection to Power (Only for U.K.)

Before Switching on make sure that the voltage of your

electricity supply is the same as that indicated on the rating

plate.

Mains Cord

This appliance may be fitted with a non-rewireable plug. If it

is necessary to change the fuse in a non-rewireable plug the fuse

cover must be refitted. If the fuse cover is lost or damaged, the

plug must not be used until a replacement available from the

appliance manufacturer is obtained.

It is important that the colour of the replacement fuse cover

corresponds with the rating marking on the base of the plug.

If the plug has to be changed because it is not suitable for your

socket, or becomes damaged, it should be cut off and an

appropriate plug fitted following the wiring instructions

below. The plug removed must be disposed of safely as

insertion into a 13A socket is likely to cause an electrical

hazard. For your own safety read the following instructions

carefully before attempting to connect this unit to mains.

The wires in this mains lead are coloured in accordance with

the following code:

BLUE=NEUTRAL, BROWN=LIVE

Important

As the colours of the wires in the mains lead of this appliance

may not correspond with the coloured markings identifying

the terminals in your plug, proceed as follows:-

The wire which is coloured blue must be connected to the

terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the

terminal which is marked with the letter L or coloured red.

No connection is to be made to the earth terminal of the plug.

If a 13 Amp (BS 1363) Plug is used, a 5 Amp Fuse must be

fitted, or if any other type of Plug is used a 5 Amp Fuse must

be fitted, either in the Plug or Adaptor, or on the Distribution

Board.

Mains Supply: 220 - 240 V 50 Hz - AC only

Do not make any connection to the larger pin marked with the

letter “E” or by the symbol or coloured green or green and

yellow.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE

TO RAIN OR MOISTURE.

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO

USER SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE

PERSONNEL.

The lightning flash with arrowhead symbol,

within an equilateral triangle, is intended to

alert the user to the presence of uninsulated

“dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude

to constitute a risk of electric shock to

persons.

The exclamation point within an equilateral

triangle is intended to alert the user to the

presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

FUSE

BLUE

(Neutral)

BROWN

(Live)

CORD GRIP

OUTER SHEATH OF THE WIRE

L5950EA(EN).fm Page 3 Friday, March 30, 2007 2:46 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Funai LCD-C2717 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info